bluetooth_audio/2.1/IBluetoothAudioProvider.hal

/*
 * Copyright (c) 2019 The Linux Foundation. All rights reserved.
 * Not a contribution.
 */

/*
 * Copyright 2018 The Android Open Source Project
 *
 * Licensed under the Apache License, Version 2.0 (the "License");
 * you may not use this file except in compliance with the License.
 * You may obtain a copy of the License at
 *
 *      http://www.apache.org/licenses/LICENSE-2.0
 *
 * Unless required by applicable law or agreed to in writing, software
 * distributed under the License is distributed on an "AS IS" BASIS,
 * WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
 * See the License for the specific language governing permissions and
 * limitations under the License.
 */

package vendor.qti.hardware.bluetooth_audio@2.1;

import @2.0::IBluetoothAudioProvider;
import @2.1::IBluetoothAudioPort;
import @2.1::AudioConfiguration;
import @2.0::Status;
import @2.0::SessionParams;
/**
 * HAL interface from the Bluetooth stack to the Audio HAL
 *
 * The Bluetooth stack calls methods in this interface to start and end audio
 * sessions and sends callback events to the Audio HAL.
 *
 * Note: For HIDL APIs with a "generates" statement, the callback parameter used
 * for return value must be invoked synchronously before the API call returns.
 */
interface IBluetoothAudioProvider extends @2.0::IBluetoothAudioProvider {

    /**
     * This method indicates that the Bluetooth stack is ready to stream audio.
     * It registers an instance of IBluetoothAudioPort with and provides the
     * current negotiated codec to the Audio HAL. After this method is called,
     * the Audio HAL can invoke IBluetoothAudioPort.startStream().
     *
     * Note: endSession() must be called to unregister this IBluetoothAudioPort
     *
     * @param hostIf An instance of IBluetoothAudioPort for stream control
     * @param audioConfig The audio configuration negotiated with the remote
     *    device. The PCM parameters are set if software based encoding,
     *    otherwise the correct codec configuration is used for hardware
     *    encoding.
     *
     * @return status One of the following
     *    SUCCESS if this IBluetoothAudioPort was successfully registered with
     *        the Audio HAL
     *    UNSUPPORTED_CODEC_CONFIGURATION if the Audio HAL cannot register this
     *        IBluetoothAudioPort with the given codec configuration
     *    FAILURE if the Audio HAL cannot register this IBluetoothAudioPort for
     *        any other reason
     * @return dataMQ The fast message queue for audio data from this provider.
     *    Audio data will be in PCM format as specified by the
     *    audioConfig.pcmConfig parameter.
     *    Invalid if streaming is offloaded to hardware or on failure.
     */
    startSession_2_1(IBluetoothAudioPort hostIf, AudioConfiguration audioConfig)
                generates (Status status, fmq_sync<uint8_t> dataMQ);
};