| /* |
| * omap3-n950-n9.dtsi - Device Tree file for Nokia N950 & N9 (common stuff) |
| * |
| * Written by: Aaro Koskinen <aaro.koskinen@iki.fi> |
| * |
| * This program is free software; you can redistribute it and/or modify |
| * it under the terms of the GNU General Public License version 2 as |
| * published by the Free Software Foundation. |
| */ |
| |
| #include "omap36xx.dtsi" |
| |
| / { |
| cpus { |
| cpu@0 { |
| cpu0-supply = <&vcc>; |
| }; |
| }; |
| |
| memory { |
| device_type = "memory"; |
| reg = <0x80000000 0x40000000>; /* 1 GB */ |
| }; |
| |
| vemmc: fixedregulator@0 { |
| compatible = "regulator-fixed"; |
| regulator-name = "VEMMC"; |
| regulator-min-microvolt = <2900000>; |
| regulator-max-microvolt = <2900000>; |
| gpio = <&gpio5 29 GPIO_ACTIVE_HIGH>; /* gpio line 157 */ |
| startup-delay-us = <150>; |
| enable-active-high; |
| }; |
| }; |
| |
| &omap3_pmx_core { |
| mmc2_pins: pinmux_mmc2_pins { |
| pinctrl-single,pins = < |
| 0x128 (PIN_INPUT_PULLUP | MUX_MODE0) /* sdmmc2_clk */ |
| 0x12a (PIN_INPUT_PULLUP | MUX_MODE0) /* sdmmc2_cmd */ |
| 0x12c (PIN_INPUT_PULLUP | MUX_MODE0) /* sdmmc2_dat0 */ |
| 0x12e (PIN_INPUT_PULLUP | MUX_MODE0) /* sdmmc2_dat1 */ |
| 0x130 (PIN_INPUT_PULLUP | MUX_MODE0) /* sdmmc2_dat2 */ |
| 0x132 (PIN_INPUT_PULLUP | MUX_MODE0) /* sdmmc2_dat3 */ |
| >; |
| }; |
| }; |
| |
| &i2c1 { |
| clock-frequency = <2900000>; |
| |
| twl: twl@48 { |
| reg = <0x48>; |
| interrupts = <7>; /* SYS_NIRQ cascaded to intc */ |
| interrupt-parent = <&intc>; |
| }; |
| }; |
| |
| /include/ "twl4030.dtsi" |
| |
| &twl { |
| compatible = "ti,twl5031"; |
| |
| twl_power: power { |
| compatible = "ti,twl4030-power"; |
| ti,use_poweroff; |
| }; |
| }; |
| |
| &twl_gpio { |
| ti,pullups = <0x000001>; /* BIT(0) */ |
| ti,pulldowns = <0x008106>; /* BIT(1) | BIT(2) | BIT(8) | BIT(15) */ |
| }; |
| |
| /* CSI-2 receiver */ |
| &vaux2 { |
| regulator-name = "vaux2"; |
| regulator-min-microvolt = <1800000>; |
| regulator-max-microvolt = <1800000>; |
| }; |
| |
| /* Cameras */ |
| &vaux3 { |
| regulator-name = "vaux3"; |
| regulator-min-microvolt = <2800000>; |
| regulator-max-microvolt = <2800000>; |
| }; |
| |
| &i2c2 { |
| clock-frequency = <400000>; |
| }; |
| |
| &i2c3 { |
| clock-frequency = <400000>; |
| }; |
| |
| &mmc1 { |
| status = "disabled"; |
| }; |
| |
| &mmc2 { |
| pinctrl-names = "default"; |
| pinctrl-0 = <&mmc2_pins>; |
| vmmc-supply = <&vemmc>; |
| bus-width = <4>; |
| ti,non-removable; |
| }; |
| |
| &mmc3 { |
| status = "disabled"; |
| }; |
| |
| &usb_otg_hs { |
| interface-type = <0>; |
| usb-phy = <&usb2_phy>; |
| phys = <&usb2_phy>; |
| phy-names = "usb2-phy"; |
| mode = <3>; |
| power = <50>; |
| }; |
| |
| &gpmc { |
| ranges = <0 0 0x04000000 0x1000000>; /* CS0: 16MB for OneNAND */ |
| |
| onenand@0,0 { |
| #address-cells = <1>; |
| #size-cells = <1>; |
| reg = <0 0 0x20000>; /* CS0, offset 0, IO size 128K */ |
| |
| gpmc,sync-read; |
| gpmc,sync-write; |
| gpmc,burst-length = <16>; |
| gpmc,burst-read; |
| gpmc,burst-wrap; |
| gpmc,burst-write; |
| gpmc,device-width = <2>; |
| gpmc,mux-add-data = <2>; |
| gpmc,cs-on-ns = <0>; |
| gpmc,cs-rd-off-ns = <87>; |
| gpmc,cs-wr-off-ns = <87>; |
| gpmc,adv-on-ns = <0>; |
| gpmc,adv-rd-off-ns = <10>; |
| gpmc,adv-wr-off-ns = <10>; |
| gpmc,oe-on-ns = <15>; |
| gpmc,oe-off-ns = <87>; |
| gpmc,we-on-ns = <0>; |
| gpmc,we-off-ns = <87>; |
| gpmc,rd-cycle-ns = <112>; |
| gpmc,wr-cycle-ns = <112>; |
| gpmc,access-ns = <81>; |
| gpmc,page-burst-access-ns = <15>; |
| gpmc,bus-turnaround-ns = <0>; |
| gpmc,cycle2cycle-delay-ns = <0>; |
| gpmc,wait-monitoring-ns = <0>; |
| gpmc,clk-activation-ns = <5>; |
| gpmc,wr-data-mux-bus-ns = <30>; |
| gpmc,wr-access-ns = <81>; |
| gpmc,sync-clk-ps = <15000>; |
| |
| /* |
| * MTD partition table corresponding to Nokia's MeeGo 1.2 |
| * Harmattan release. |
| */ |
| partition@0 { |
| label = "bootloader"; |
| reg = <0x00000000 0x00100000>; |
| }; |
| partition@1 { |
| label = "config"; |
| reg = <0x00100000 0x002c0000>; |
| }; |
| partition@2 { |
| label = "kernel"; |
| reg = <0x003c0000 0x01000000>; |
| }; |
| partition@3 { |
| label = "log"; |
| reg = <0x013c0000 0x00200000>; |
| }; |
| partition@4 { |
| label = "var"; |
| reg = <0x015c0000 0x1ca40000>; |
| }; |
| partition@5 { |
| label = "moslo"; |
| reg = <0x1e000000 0x02000000>; |
| }; |
| partition@6 { |
| label = "omap2-onenand"; |
| reg = <0x00000000 0x20000000>; |
| }; |
| }; |
| }; |