| config INFINIBAND_IPOIB |
| tristate "IP-over-InfiniBand" |
| depends on NETDEVICES && INET && (IPV6 || IPV6=n) |
| select INET_LRO |
| ---help--- |
| Support for the IP-over-InfiniBand protocol (IPoIB). This |
| transports IP packets over InfiniBand so you can use your IB |
| device as a fancy NIC. |
| |
| See Documentation/infiniband/ipoib.txt for more information |
| |
| config INFINIBAND_IPOIB_CM |
| bool "IP-over-InfiniBand Connected Mode support" |
| depends on INFINIBAND_IPOIB && EXPERIMENTAL |
| default n |
| ---help--- |
| This option enables experimental support for IPoIB connected mode. |
| After enabling this option, you need to switch to connected mode through |
| /sys/class/net/ibXXX/mode to actually create connections, and then increase |
| the interface MTU with e.g. ifconfig ib0 mtu 65520. |
| |
| WARNING: Enabling connected mode will trigger some |
| packet drops for multicast and UD mode traffic from this interface, |
| unless you limit mtu for these destinations to 2044. |
| |
| config INFINIBAND_IPOIB_DEBUG |
| bool "IP-over-InfiniBand debugging" if EMBEDDED |
| depends on INFINIBAND_IPOIB |
| default y |
| ---help--- |
| This option causes debugging code to be compiled into the |
| IPoIB driver. The output can be turned on via the |
| debug_level and mcast_debug_level module parameters (which |
| can also be set after the driver is loaded through sysfs). |
| |
| This option also creates an "ipoib_debugfs," which can be |
| mounted to expose debugging information about IB multicast |
| groups used by the IPoIB driver. |
| |
| config INFINIBAND_IPOIB_DEBUG_DATA |
| bool "IP-over-InfiniBand data path debugging" |
| depends on INFINIBAND_IPOIB_DEBUG |
| ---help--- |
| This option compiles debugging code into the data path |
| of the IPoIB driver. The output can be turned on via the |
| data_debug_level module parameter; however, even with output |
| turned off, this debugging code will have some performance |
| impact. |