| /* |
| * omap_udc.h -- for omap 3.2 udc, with OTG support |
| * |
| * 2004 (C) Texas Instruments, Inc. |
| * 2004 (C) David Brownell |
| */ |
| |
| /* |
| * USB device/endpoint management registers |
| */ |
| #define UDC_REG(offset) __REG16(UDC_BASE + (offset)) |
| |
| #define UDC_REV_REG UDC_REG(0x0) /* Revision */ |
| #define UDC_EP_NUM_REG UDC_REG(0x4) /* Which endpoint */ |
| # define UDC_SETUP_SEL (1 << 6) |
| # define UDC_EP_SEL (1 << 5) |
| # define UDC_EP_DIR (1 << 4) |
| /* low 4 bits for endpoint number */ |
| #define UDC_DATA_REG UDC_REG(0x08) /* Endpoint FIFO */ |
| #define UDC_CTRL_REG UDC_REG(0x0C) /* Endpoint control */ |
| # define UDC_CLR_HALT (1 << 7) |
| # define UDC_SET_HALT (1 << 6) |
| # define UDC_SET_FIFO_EN (1 << 2) |
| # define UDC_CLR_EP (1 << 1) |
| # define UDC_RESET_EP (1 << 0) |
| #define UDC_STAT_FLG_REG UDC_REG(0x10) /* Endpoint status */ |
| # define UDC_NO_RXPACKET (1 << 15) |
| # define UDC_MISS_IN (1 << 14) |
| # define UDC_DATA_FLUSH (1 << 13) |
| # define UDC_ISO_ERR (1 << 12) |
| # define UDC_ISO_FIFO_EMPTY (1 << 9) |
| # define UDC_ISO_FIFO_FULL (1 << 8) |
| # define UDC_EP_HALTED (1 << 6) |
| # define UDC_STALL (1 << 5) |
| # define UDC_NAK (1 << 4) |
| # define UDC_ACK (1 << 3) |
| # define UDC_FIFO_EN (1 << 2) |
| # define UDC_NON_ISO_FIFO_EMPTY (1 << 1) |
| # define UDC_NON_ISO_FIFO_FULL (1 << 0) |
| #define UDC_RXFSTAT_REG UDC_REG(0x14) /* OUT bytecount */ |
| #define UDC_SYSCON1_REG UDC_REG(0x18) /* System config 1 */ |
| # define UDC_CFG_LOCK (1 << 8) |
| # define UDC_DATA_ENDIAN (1 << 7) |
| # define UDC_DMA_ENDIAN (1 << 6) |
| # define UDC_NAK_EN (1 << 4) |
| # define UDC_AUTODECODE_DIS (1 << 3) |
| # define UDC_SELF_PWR (1 << 2) |
| # define UDC_SOFF_DIS (1 << 1) |
| # define UDC_PULLUP_EN (1 << 0) |
| #define UDC_SYSCON2_REG UDC_REG(0x1C) /* System config 2 */ |
| # define UDC_RMT_WKP (1 << 6) |
| # define UDC_STALL_CMD (1 << 5) |
| # define UDC_DEV_CFG (1 << 3) |
| # define UDC_CLR_CFG (1 << 2) |
| #define UDC_DEVSTAT_REG UDC_REG(0x20) /* Device status */ |
| # define UDC_B_HNP_ENABLE (1 << 9) |
| # define UDC_A_HNP_SUPPORT (1 << 8) |
| # define UDC_A_ALT_HNP_SUPPORT (1 << 7) |
| # define UDC_R_WK_OK (1 << 6) |
| # define UDC_USB_RESET (1 << 5) |
| # define UDC_SUS (1 << 4) |
| # define UDC_CFG (1 << 3) |
| # define UDC_ADD (1 << 2) |
| # define UDC_DEF (1 << 1) |
| # define UDC_ATT (1 << 0) |
| #define UDC_SOF_REG UDC_REG(0x24) /* Start of frame */ |
| # define UDC_FT_LOCK (1 << 12) |
| # define UDC_TS_OK (1 << 11) |
| # define UDC_TS 0x03ff |
| #define UDC_IRQ_EN_REG UDC_REG(0x28) /* Interrupt enable */ |
| # define UDC_SOF_IE (1 << 7) |
| # define UDC_EPN_RX_IE (1 << 5) |
| # define UDC_EPN_TX_IE (1 << 4) |
| # define UDC_DS_CHG_IE (1 << 3) |
| # define UDC_EP0_IE (1 << 0) |
| #define UDC_DMA_IRQ_EN_REG UDC_REG(0x2C) /* DMA irq enable */ |
| /* rx/tx dma channels numbered 1-3 not 0-2 */ |
| # define UDC_TX_DONE_IE(n) (1 << (4 * (n) - 2)) |
| # define UDC_RX_CNT_IE(n) (1 << (4 * (n) - 3)) |
| # define UDC_RX_EOT_IE(n) (1 << (4 * (n) - 4)) |
| #define UDC_IRQ_SRC_REG UDC_REG(0x30) /* Interrupt source */ |
| # define UDC_TXN_DONE (1 << 10) |
| # define UDC_RXN_CNT (1 << 9) |
| # define UDC_RXN_EOT (1 << 8) |
| # define UDC_SOF (1 << 7) |
| # define UDC_EPN_RX (1 << 5) |
| # define UDC_EPN_TX (1 << 4) |
| # define UDC_DS_CHG (1 << 3) |
| # define UDC_SETUP (1 << 2) |
| # define UDC_EP0_RX (1 << 1) |
| # define UDC_EP0_TX (1 << 0) |
| # define UDC_IRQ_SRC_MASK 0x7bf |
| #define UDC_EPN_STAT_REG UDC_REG(0x34) /* EP irq status */ |
| #define UDC_DMAN_STAT_REG UDC_REG(0x38) /* DMA irq status */ |
| # define UDC_DMA_RX_SB (1 << 12) |
| # define UDC_DMA_RX_SRC(x) (((x)>>8) & 0xf) |
| # define UDC_DMA_TX_SRC(x) (((x)>>0) & 0xf) |
| |
| |
| /* DMA configuration registers: up to three channels in each direction. */ |
| #define UDC_RXDMA_CFG_REG UDC_REG(0x40) /* 3 eps for RX DMA */ |
| #define UDC_TXDMA_CFG_REG UDC_REG(0x44) /* 3 eps for TX DMA */ |
| #define UDC_DATA_DMA_REG UDC_REG(0x48) /* rx/tx fifo addr */ |
| |
| /* rx/tx dma control, numbering channels 1-3 not 0-2 */ |
| #define UDC_TXDMA_REG(chan) UDC_REG(0x50 - 4 + 4 * (chan)) |
| # define UDC_TXN_EOT (1 << 15) /* bytes vs packets */ |
| # define UDC_TXN_START (1 << 14) /* start transfer */ |
| # define UDC_TXN_TSC 0x03ff /* units in xfer */ |
| #define UDC_RXDMA_REG(chan) UDC_REG(0x60 - 4 + 4 * (chan)) |
| # define UDC_RXN_STOP (1 << 15) /* enable EOT irq */ |
| # define UDC_RXN_TC 0x00ff /* packets in xfer */ |
| |
| |
| /* |
| * Endpoint configuration registers (used before CFG_LOCK is set) |
| * UDC_EP_TX_REG(0) is unused |
| */ |
| #define UDC_EP_RX_REG(endpoint) UDC_REG(0x80 + (endpoint)*4) |
| # define UDC_EPN_RX_VALID (1 << 15) |
| # define UDC_EPN_RX_DB (1 << 14) |
| /* buffer size in bits 13, 12 */ |
| # define UDC_EPN_RX_ISO (1 << 11) |
| /* buffer pointer in low 11 bits */ |
| #define UDC_EP_TX_REG(endpoint) UDC_REG(0xc0 + (endpoint)*4) |
| /* same bitfields as in RX_REG */ |
| |
| /*-------------------------------------------------------------------------*/ |
| |
| struct omap_req { |
| struct usb_request req; |
| struct list_head queue; |
| unsigned dma_bytes; |
| unsigned mapped:1; |
| }; |
| |
| struct omap_ep { |
| struct usb_ep ep; |
| struct list_head queue; |
| unsigned long irqs; |
| struct list_head iso; |
| const struct usb_endpoint_descriptor *desc; |
| char name[14]; |
| u16 maxpacket; |
| u8 bEndpointAddress; |
| u8 bmAttributes; |
| unsigned double_buf:1; |
| unsigned stopped:1; |
| unsigned fnf:1; |
| unsigned has_dma:1; |
| u8 ackwait; |
| u8 dma_channel; |
| u16 dma_counter; |
| int lch; |
| struct omap_udc *udc; |
| struct timer_list timer; |
| }; |
| |
| struct omap_udc { |
| struct usb_gadget gadget; |
| struct usb_gadget_driver *driver; |
| spinlock_t lock; |
| struct omap_ep ep[32]; |
| u16 devstat; |
| struct otg_transceiver *transceiver; |
| struct list_head iso; |
| unsigned softconnect:1; |
| unsigned vbus_active:1; |
| unsigned ep0_pending:1; |
| unsigned ep0_in:1; |
| unsigned ep0_set_config:1; |
| unsigned ep0_reset_config:1; |
| unsigned ep0_setup:1; |
| |
| struct completion *done; |
| }; |
| |
| /*-------------------------------------------------------------------------*/ |
| |
| #ifdef DEBUG |
| #define DBG(stuff...) printk(KERN_DEBUG "udc: " stuff) |
| #else |
| #define DBG(stuff...) do{}while(0) |
| #endif |
| |
| #ifdef VERBOSE |
| # define VDBG DBG |
| #else |
| # define VDBG(stuff...) do{}while(0) |
| #endif |
| |
| #define ERR(stuff...) printk(KERN_ERR "udc: " stuff) |
| #define WARN(stuff...) printk(KERN_WARNING "udc: " stuff) |
| #define INFO(stuff...) printk(KERN_INFO "udc: " stuff) |
| |
| /*-------------------------------------------------------------------------*/ |
| |
| #define MOD_CONF_CTRL_0_REG __REG32(MOD_CONF_CTRL_0) |
| #define VBUS_W2FC_1510 (1 << 17) /* 0 gpio0, 1 dvdd2 pin */ |
| |
| #define FUNC_MUX_CTRL_0_REG __REG32(FUNC_MUX_CTRL_0) |
| #define VBUS_CTRL_1510 (1 << 19) /* 1 connected (software) */ |
| #define VBUS_MODE_1510 (1 << 18) /* 0 hardware, 1 software */ |
| |
| #define HMC_1510 ((MOD_CONF_CTRL_0_REG >> 1) & 0x3f) |
| #define HMC_1610 (OTG_SYSCON_2_REG & 0x3f) |
| #define HMC (cpu_is_omap15xx() ? HMC_1510 : HMC_1610) |
| |