| #ifndef _ARCH_MCI_H |
| #define _ARCH_MCI_H |
| |
| /** |
| * struct s3c24xx_mci_pdata - sd/mmc controller platform data |
| * @no_wprotect: Set this to indicate there is no write-protect switch. |
| * @no_detect: Set this if there is no detect switch. |
| * @wprotect_invert: Invert the default sense of the write protect switch. |
| * @detect_invert: Invert the default sense of the write protect switch. |
| * @use_dma: Set to allow the use of DMA. |
| * @gpio_detect: GPIO number for the card detect line. |
| * @gpio_wprotect: GPIO number for the write protect line. |
| * @ocr_avail: The mask of the available power states, non-zero to use. |
| * @set_power: Callback to control the power mode. |
| * |
| * The @gpio_detect is used for card detection when @no_wprotect is unset, |
| * and the default sense is that 0 returned from gpio_get_value() means |
| * that a card is inserted. If @detect_invert is set, then the value from |
| * gpio_get_value() is inverted, which makes 1 mean card inserted. |
| * |
| * The driver will use @gpio_wprotect to signal whether the card is write |
| * protected if @no_wprotect is not set. A 0 returned from gpio_get_value() |
| * means the card is read/write, and 1 means read-only. The @wprotect_invert |
| * will invert the value returned from gpio_get_value(). |
| * |
| * Card power is set by @ocr_availa, using MCC_VDD_ constants if it is set |
| * to a non-zero value, otherwise the default of 3.2-3.4V is used. |
| */ |
| struct s3c24xx_mci_pdata { |
| unsigned int no_wprotect : 1; |
| unsigned int no_detect : 1; |
| unsigned int wprotect_invert : 1; |
| unsigned int detect_invert : 1; /* set => detect active high. */ |
| unsigned int use_dma : 1; |
| |
| unsigned int gpio_detect; |
| unsigned int gpio_wprotect; |
| unsigned long ocr_avail; |
| void (*set_power)(unsigned char power_mode, |
| unsigned short vdd); |
| }; |
| |
| #endif /* _ARCH_NCI_H */ |