| #ifndef _ASM_X86_MCE_H |
| #define _ASM_X86_MCE_H |
| |
| #include <uapi/asm/mce.h> |
| |
| /* |
| * Machine Check support for x86 |
| */ |
| |
| /* MCG_CAP register defines */ |
| #define MCG_BANKCNT_MASK 0xff /* Number of Banks */ |
| #define MCG_CTL_P (1ULL<<8) /* MCG_CTL register available */ |
| #define MCG_EXT_P (1ULL<<9) /* Extended registers available */ |
| #define MCG_CMCI_P (1ULL<<10) /* CMCI supported */ |
| #define MCG_EXT_CNT_MASK 0xff0000 /* Number of Extended registers */ |
| #define MCG_EXT_CNT_SHIFT 16 |
| #define MCG_EXT_CNT(c) (((c) & MCG_EXT_CNT_MASK) >> MCG_EXT_CNT_SHIFT) |
| #define MCG_SER_P (1ULL<<24) /* MCA recovery/new status bits */ |
| |
| /* MCG_STATUS register defines */ |
| #define MCG_STATUS_RIPV (1ULL<<0) /* restart ip valid */ |
| #define MCG_STATUS_EIPV (1ULL<<1) /* ip points to correct instruction */ |
| #define MCG_STATUS_MCIP (1ULL<<2) /* machine check in progress */ |
| |
| /* MCi_STATUS register defines */ |
| #define MCI_STATUS_VAL (1ULL<<63) /* valid error */ |
| #define MCI_STATUS_OVER (1ULL<<62) /* previous errors lost */ |
| #define MCI_STATUS_UC (1ULL<<61) /* uncorrected error */ |
| #define MCI_STATUS_EN (1ULL<<60) /* error enabled */ |
| #define MCI_STATUS_MISCV (1ULL<<59) /* misc error reg. valid */ |
| #define MCI_STATUS_ADDRV (1ULL<<58) /* addr reg. valid */ |
| #define MCI_STATUS_PCC (1ULL<<57) /* processor context corrupt */ |
| #define MCI_STATUS_S (1ULL<<56) /* Signaled machine check */ |
| #define MCI_STATUS_AR (1ULL<<55) /* Action required */ |
| #define MCACOD 0xffff /* MCA Error Code */ |
| |
| /* Architecturally defined codes from SDM Vol. 3B Chapter 15 */ |
| #define MCACOD_SCRUB 0x00C0 /* 0xC0-0xCF Memory Scrubbing */ |
| #define MCACOD_SCRUBMSK 0xfff0 |
| #define MCACOD_L3WB 0x017A /* L3 Explicit Writeback */ |
| #define MCACOD_DATA 0x0134 /* Data Load */ |
| #define MCACOD_INSTR 0x0150 /* Instruction Fetch */ |
| |
| /* MCi_MISC register defines */ |
| #define MCI_MISC_ADDR_LSB(m) ((m) & 0x3f) |
| #define MCI_MISC_ADDR_MODE(m) (((m) >> 6) & 7) |
| #define MCI_MISC_ADDR_SEGOFF 0 /* segment offset */ |
| #define MCI_MISC_ADDR_LINEAR 1 /* linear address */ |
| #define MCI_MISC_ADDR_PHYS 2 /* physical address */ |
| #define MCI_MISC_ADDR_MEM 3 /* memory address */ |
| #define MCI_MISC_ADDR_GENERIC 7 /* generic */ |
| |
| /* CTL2 register defines */ |
| #define MCI_CTL2_CMCI_EN (1ULL << 30) |
| #define MCI_CTL2_CMCI_THRESHOLD_MASK 0x7fffULL |
| |
| #define MCJ_CTX_MASK 3 |
| #define MCJ_CTX(flags) ((flags) & MCJ_CTX_MASK) |
| #define MCJ_CTX_RANDOM 0 /* inject context: random */ |
| #define MCJ_CTX_PROCESS 0x1 /* inject context: process */ |
| #define MCJ_CTX_IRQ 0x2 /* inject context: IRQ */ |
| #define MCJ_NMI_BROADCAST 0x4 /* do NMI broadcasting */ |
| #define MCJ_EXCEPTION 0x8 /* raise as exception */ |
| #define MCJ_IRQ_BROADCAST 0x10 /* do IRQ broadcasting */ |
| |
| #define MCE_OVERFLOW 0 /* bit 0 in flags means overflow */ |
| |
| /* Software defined banks */ |
| #define MCE_EXTENDED_BANK 128 |
| #define MCE_THERMAL_BANK (MCE_EXTENDED_BANK + 0) |
| #define K8_MCE_THRESHOLD_BASE (MCE_EXTENDED_BANK + 1) |
| |
| #define MCE_LOG_LEN 32 |
| #define MCE_LOG_SIGNATURE "MACHINECHECK" |
| |
| /* |
| * This structure contains all data related to the MCE log. Also |
| * carries a signature to make it easier to find from external |
| * debugging tools. Each entry is only valid when its finished flag |
| * is set. |
| */ |
| struct mce_log { |
| char signature[12]; /* "MACHINECHECK" */ |
| unsigned len; /* = MCE_LOG_LEN */ |
| unsigned next; |
| unsigned flags; |
| unsigned recordlen; /* length of struct mce */ |
| struct mce entry[MCE_LOG_LEN]; |
| }; |
| |
| struct mca_config { |
| bool dont_log_ce; |
| bool cmci_disabled; |
| bool ignore_ce; |
| bool disabled; |
| bool ser; |
| bool bios_cmci_threshold; |
| u8 banks; |
| s8 bootlog; |
| int tolerant; |
| int monarch_timeout; |
| int panic_timeout; |
| u32 rip_msr; |
| }; |
| |
| extern struct mca_config mca_cfg; |
| extern void mce_register_decode_chain(struct notifier_block *nb); |
| extern void mce_unregister_decode_chain(struct notifier_block *nb); |
| |
| #include <linux/percpu.h> |
| #include <linux/init.h> |
| #include <linux/atomic.h> |
| |
| extern int mce_p5_enabled; |
| |
| #ifdef CONFIG_X86_MCE |
| int mcheck_init(void); |
| void mcheck_cpu_init(struct cpuinfo_x86 *c); |
| #else |
| static inline int mcheck_init(void) { return 0; } |
| static inline void mcheck_cpu_init(struct cpuinfo_x86 *c) {} |
| #endif |
| |
| #ifdef CONFIG_X86_ANCIENT_MCE |
| void intel_p5_mcheck_init(struct cpuinfo_x86 *c); |
| void winchip_mcheck_init(struct cpuinfo_x86 *c); |
| static inline void enable_p5_mce(void) { mce_p5_enabled = 1; } |
| #else |
| static inline void intel_p5_mcheck_init(struct cpuinfo_x86 *c) {} |
| static inline void winchip_mcheck_init(struct cpuinfo_x86 *c) {} |
| static inline void enable_p5_mce(void) {} |
| #endif |
| |
| void mce_setup(struct mce *m); |
| void mce_log(struct mce *m); |
| DECLARE_PER_CPU(struct device *, mce_device); |
| |
| /* |
| * Maximum banks number. |
| * This is the limit of the current register layout on |
| * Intel CPUs. |
| */ |
| #define MAX_NR_BANKS 32 |
| |
| #ifdef CONFIG_X86_MCE_INTEL |
| void mce_intel_feature_init(struct cpuinfo_x86 *c); |
| void cmci_clear(void); |
| void cmci_reenable(void); |
| void cmci_rediscover(void); |
| void cmci_recheck(void); |
| #else |
| static inline void mce_intel_feature_init(struct cpuinfo_x86 *c) { } |
| static inline void cmci_clear(void) {} |
| static inline void cmci_reenable(void) {} |
| static inline void cmci_rediscover(void) {} |
| static inline void cmci_recheck(void) {} |
| #endif |
| |
| #ifdef CONFIG_X86_MCE_AMD |
| void mce_amd_feature_init(struct cpuinfo_x86 *c); |
| #else |
| static inline void mce_amd_feature_init(struct cpuinfo_x86 *c) { } |
| #endif |
| |
| int mce_available(struct cpuinfo_x86 *c); |
| |
| DECLARE_PER_CPU(unsigned, mce_exception_count); |
| DECLARE_PER_CPU(unsigned, mce_poll_count); |
| |
| extern atomic_t mce_entry; |
| |
| typedef DECLARE_BITMAP(mce_banks_t, MAX_NR_BANKS); |
| DECLARE_PER_CPU(mce_banks_t, mce_poll_banks); |
| |
| enum mcp_flags { |
| MCP_TIMESTAMP = (1 << 0), /* log time stamp */ |
| MCP_UC = (1 << 1), /* log uncorrected errors */ |
| MCP_DONTLOG = (1 << 2), /* only clear, don't log */ |
| }; |
| void machine_check_poll(enum mcp_flags flags, mce_banks_t *b); |
| |
| int mce_notify_irq(void); |
| void mce_notify_process(void); |
| |
| DECLARE_PER_CPU(struct mce, injectm); |
| |
| extern void register_mce_write_callback(ssize_t (*)(struct file *filp, |
| const char __user *ubuf, |
| size_t usize, loff_t *off)); |
| |
| /* |
| * Exception handler |
| */ |
| |
| /* Call the installed machine check handler for this CPU setup. */ |
| extern void (*machine_check_vector)(struct pt_regs *, long error_code); |
| void do_machine_check(struct pt_regs *, long); |
| |
| /* |
| * Threshold handler |
| */ |
| |
| extern void (*mce_threshold_vector)(void); |
| extern void (*threshold_cpu_callback)(unsigned long action, unsigned int cpu); |
| |
| /* |
| * Thermal handler |
| */ |
| |
| void intel_init_thermal(struct cpuinfo_x86 *c); |
| |
| void mce_log_therm_throt_event(__u64 status); |
| |
| /* Interrupt Handler for core thermal thresholds */ |
| extern int (*platform_thermal_notify)(__u64 msr_val); |
| |
| /* Interrupt Handler for package thermal thresholds */ |
| extern int (*platform_thermal_package_notify)(__u64 msr_val); |
| |
| /* Callback support of rate control, return true, if |
| * callback has rate control */ |
| extern bool (*platform_thermal_package_rate_control)(void); |
| |
| #ifdef CONFIG_X86_THERMAL_VECTOR |
| extern void mcheck_intel_therm_init(void); |
| #else |
| static inline void mcheck_intel_therm_init(void) { } |
| #endif |
| |
| /* |
| * Used by APEI to report memory error via /dev/mcelog |
| */ |
| |
| struct cper_sec_mem_err; |
| extern void apei_mce_report_mem_error(int corrected, |
| struct cper_sec_mem_err *mem_err); |
| |
| #endif /* _ASM_X86_MCE_H */ |