| Renesas Electronics USBHS driver |
| |
| Required properties: |
| - compatible: Must contain one of the following: |
| - "renesas,usbhs-r8a7790" |
| - "renesas,usbhs-r8a7791" |
| - reg: Base address and length of the register for the USBHS |
| - interrupts: Interrupt specifier for the USBHS |
| - clocks: A list of phandle + clock specifier pairs |
| |
| Optional properties: |
| - renesas,buswait: Integer to use BUSWAIT register |
| - renesas,enable-gpio: A gpio specifier to check GPIO determining if USB |
| function should be enabled |
| - phys: phandle + phy specifier pair |
| - phy-names: must be "usb" |
| - dmas: Must contain a list of references to DMA specifiers. |
| - dma-names : Must contain a list of DMA names, "tx" or "rx". |
| |
| Example: |
| usbhs: usb@e6590000 { |
| compatible = "renesas,usbhs-r8a7790"; |
| reg = <0 0xe6590000 0 0x100>; |
| interrupts = <0 107 IRQ_TYPE_LEVEL_HIGH>; |
| clocks = <&mstp7_clks R8A7790_CLK_HSUSB>; |
| }; |