| /* |
| * Copyright (C) 2000 - 2007 Jeff Dike (jdike@{addtoit,linux.intel}.com) |
| * Licensed under the GPL |
| */ |
| |
| #include <linux/mm.h> |
| #include <linux/sched.h> |
| #include <linux/hardirq.h> |
| #include <asm/current.h> |
| #include <asm/pgtable.h> |
| #include <asm/tlbflush.h> |
| #include "arch.h" |
| #include "as-layout.h" |
| #include "kern_util.h" |
| #include "os.h" |
| #include "skas.h" |
| #include "sysdep/sigcontext.h" |
| |
| /* |
| * Note this is constrained to return 0, -EFAULT, -EACCESS, -ENOMEM by |
| * segv(). |
| */ |
| int handle_page_fault(unsigned long address, unsigned long ip, |
| int is_write, int is_user, int *code_out) |
| { |
| struct mm_struct *mm = current->mm; |
| struct vm_area_struct *vma; |
| pgd_t *pgd; |
| pud_t *pud; |
| pmd_t *pmd; |
| pte_t *pte; |
| int err = -EFAULT; |
| |
| *code_out = SEGV_MAPERR; |
| |
| /* |
| * If the fault was during atomic operation, don't take the fault, just |
| * fail. |
| */ |
| if (in_atomic()) |
| goto out_nosemaphore; |
| |
| down_read(&mm->mmap_sem); |
| vma = find_vma(mm, address); |
| if (!vma) |
| goto out; |
| else if (vma->vm_start <= address) |
| goto good_area; |
| else if (!(vma->vm_flags & VM_GROWSDOWN)) |
| goto out; |
| else if (is_user && !ARCH_IS_STACKGROW(address)) |
| goto out; |
| else if (expand_stack(vma, address)) |
| goto out; |
| |
| good_area: |
| *code_out = SEGV_ACCERR; |
| if (is_write && !(vma->vm_flags & VM_WRITE)) |
| goto out; |
| |
| /* Don't require VM_READ|VM_EXEC for write faults! */ |
| if (!is_write && !(vma->vm_flags & (VM_READ | VM_EXEC))) |
| goto out; |
| |
| do { |
| int fault; |
| survive: |
| fault = handle_mm_fault(mm, vma, address, is_write); |
| if (unlikely(fault & VM_FAULT_ERROR)) { |
| if (fault & VM_FAULT_OOM) { |
| err = -ENOMEM; |
| goto out_of_memory; |
| } else if (fault & VM_FAULT_SIGBUS) { |
| err = -EACCES; |
| goto out; |
| } |
| BUG(); |
| } |
| if (fault & VM_FAULT_MAJOR) |
| current->maj_flt++; |
| else |
| current->min_flt++; |
| |
| pgd = pgd_offset(mm, address); |
| pud = pud_offset(pgd, address); |
| pmd = pmd_offset(pud, address); |
| pte = pte_offset_kernel(pmd, address); |
| } while (!pte_present(*pte)); |
| err = 0; |
| /* |
| * The below warning was added in place of |
| * pte_mkyoung(); if (is_write) pte_mkdirty(); |
| * If it's triggered, we'd see normally a hang here (a clean pte is |
| * marked read-only to emulate the dirty bit). |
| * However, the generic code can mark a PTE writable but clean on a |
| * concurrent read fault, triggering this harmlessly. So comment it out. |
| */ |
| #if 0 |
| WARN_ON(!pte_young(*pte) || (is_write && !pte_dirty(*pte))); |
| #endif |
| flush_tlb_page(vma, address); |
| out: |
| up_read(&mm->mmap_sem); |
| out_nosemaphore: |
| return err; |
| |
| /* |
| * We ran out of memory, or some other thing happened to us that made |
| * us unable to handle the page fault gracefully. |
| */ |
| out_of_memory: |
| if (is_global_init(current)) { |
| up_read(&mm->mmap_sem); |
| yield(); |
| down_read(&mm->mmap_sem); |
| goto survive; |
| } |
| goto out; |
| } |
| |
| static void bad_segv(struct faultinfo fi, unsigned long ip) |
| { |
| struct siginfo si; |
| |
| si.si_signo = SIGSEGV; |
| si.si_code = SEGV_ACCERR; |
| si.si_addr = (void __user *) FAULT_ADDRESS(fi); |
| current->thread.arch.faultinfo = fi; |
| force_sig_info(SIGSEGV, &si, current); |
| } |
| |
| void fatal_sigsegv(void) |
| { |
| force_sigsegv(SIGSEGV, current); |
| do_signal(); |
| /* |
| * This is to tell gcc that we're not returning - do_signal |
| * can, in general, return, but in this case, it's not, since |
| * we just got a fatal SIGSEGV queued. |
| */ |
| os_dump_core(); |
| } |
| |
| void segv_handler(int sig, struct uml_pt_regs *regs) |
| { |
| struct faultinfo * fi = UPT_FAULTINFO(regs); |
| |
| if (UPT_IS_USER(regs) && !SEGV_IS_FIXABLE(fi)) { |
| bad_segv(*fi, UPT_IP(regs)); |
| return; |
| } |
| segv(*fi, UPT_IP(regs), UPT_IS_USER(regs), regs); |
| } |
| |
| /* |
| * We give a *copy* of the faultinfo in the regs to segv. |
| * This must be done, since nesting SEGVs could overwrite |
| * the info in the regs. A pointer to the info then would |
| * give us bad data! |
| */ |
| unsigned long segv(struct faultinfo fi, unsigned long ip, int is_user, |
| struct uml_pt_regs *regs) |
| { |
| struct siginfo si; |
| jmp_buf *catcher; |
| int err; |
| int is_write = FAULT_WRITE(fi); |
| unsigned long address = FAULT_ADDRESS(fi); |
| |
| if (!is_user && (address >= start_vm) && (address < end_vm)) { |
| flush_tlb_kernel_vm(); |
| return 0; |
| } |
| else if (current->mm == NULL) { |
| show_regs(container_of(regs, struct pt_regs, regs)); |
| panic("Segfault with no mm"); |
| } |
| |
| if (SEGV_IS_FIXABLE(&fi) || SEGV_MAYBE_FIXABLE(&fi)) |
| err = handle_page_fault(address, ip, is_write, is_user, |
| &si.si_code); |
| else { |
| err = -EFAULT; |
| /* |
| * A thread accessed NULL, we get a fault, but CR2 is invalid. |
| * This code is used in __do_copy_from_user() of TT mode. |
| * XXX tt mode is gone, so maybe this isn't needed any more |
| */ |
| address = 0; |
| } |
| |
| catcher = current->thread.fault_catcher; |
| if (!err) |
| return 0; |
| else if (catcher != NULL) { |
| current->thread.fault_addr = (void *) address; |
| UML_LONGJMP(catcher, 1); |
| } |
| else if (current->thread.fault_addr != NULL) |
| panic("fault_addr set but no fault catcher"); |
| else if (!is_user && arch_fixup(ip, regs)) |
| return 0; |
| |
| if (!is_user) { |
| show_regs(container_of(regs, struct pt_regs, regs)); |
| panic("Kernel mode fault at addr 0x%lx, ip 0x%lx", |
| address, ip); |
| } |
| |
| if (err == -EACCES) { |
| si.si_signo = SIGBUS; |
| si.si_errno = 0; |
| si.si_code = BUS_ADRERR; |
| si.si_addr = (void __user *)address; |
| current->thread.arch.faultinfo = fi; |
| force_sig_info(SIGBUS, &si, current); |
| } else if (err == -ENOMEM) { |
| printk(KERN_INFO "VM: killing process %s\n", current->comm); |
| do_exit(SIGKILL); |
| } else { |
| BUG_ON(err != -EFAULT); |
| si.si_signo = SIGSEGV; |
| si.si_addr = (void __user *) address; |
| current->thread.arch.faultinfo = fi; |
| force_sig_info(SIGSEGV, &si, current); |
| } |
| return 0; |
| } |
| |
| void relay_signal(int sig, struct uml_pt_regs *regs) |
| { |
| if (!UPT_IS_USER(regs)) { |
| if (sig == SIGBUS) |
| printk(KERN_ERR "Bus error - the host /dev/shm or /tmp " |
| "mount likely just ran out of space\n"); |
| panic("Kernel mode signal %d", sig); |
| } |
| |
| arch_examine_signal(sig, regs); |
| |
| current->thread.arch.faultinfo = *UPT_FAULTINFO(regs); |
| force_sig(sig, current); |
| } |
| |
| void bus_handler(int sig, struct uml_pt_regs *regs) |
| { |
| if (current->thread.fault_catcher != NULL) |
| UML_LONGJMP(current->thread.fault_catcher, 1); |
| else relay_signal(sig, regs); |
| } |
| |
| void winch(int sig, struct uml_pt_regs *regs) |
| { |
| do_IRQ(WINCH_IRQ, regs); |
| } |
| |
| void trap_init(void) |
| { |
| } |