bonding: make USES_PRIMARY inline functions
Change the name a bit to better reflect its scope, and update some
comments. Two functions added - one which takes bond as a param and the
other which takes the mode.
CC: Jay Vosburgh <j.vosburgh@gmail.com>
CC: Andy Gospodarek <andy@greyhouse.net>
Signed-off-by: Veaceslav Falico <vfalico@gmail.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/bonding/bond_main.c b/drivers/net/bonding/bond_main.c
index 2448e28..48bea62 100644
--- a/drivers/net/bonding/bond_main.c
+++ b/drivers/net/bonding/bond_main.c
@@ -497,7 +497,7 @@
struct list_head *iter;
int err = 0;
- if (USES_PRIMARY(bond->params.mode)) {
+ if (bond_uses_primary(bond)) {
/* write lock already acquired */
if (bond->curr_active_slave) {
err = dev_set_promiscuity(bond->curr_active_slave->dev,
@@ -523,7 +523,7 @@
struct list_head *iter;
int err = 0;
- if (USES_PRIMARY(bond->params.mode)) {
+ if (bond_uses_primary(bond)) {
/* write lock already acquired */
if (bond->curr_active_slave) {
err = dev_set_allmulti(bond->curr_active_slave->dev,
@@ -585,8 +585,8 @@
/*--------------------------- Active slave change ---------------------------*/
/* Update the hardware address list and promisc/allmulti for the new and
- * old active slaves (if any). Modes that are !USES_PRIMARY keep all
- * slaves up date at all times; only the USES_PRIMARY modes need to call
+ * old active slaves (if any). Modes that are not using primary keep all
+ * slaves up date at all times; only the modes that use primary need to call
* this function to swap these settings during a failover.
*/
static void bond_hw_addr_swap(struct bonding *bond, struct slave *new_active,
@@ -801,7 +801,7 @@
new_active->last_link_up = jiffies;
if (new_active->link == BOND_LINK_BACK) {
- if (USES_PRIMARY(bond->params.mode)) {
+ if (bond_uses_primary(bond)) {
pr_info("%s: making interface %s the new active one %d ms earlier\n",
bond->dev->name, new_active->dev->name,
(bond->params.updelay - new_active->delay) * bond->params.miimon);
@@ -816,14 +816,14 @@
if (bond_is_lb(bond))
bond_alb_handle_link_change(bond, new_active, BOND_LINK_UP);
} else {
- if (USES_PRIMARY(bond->params.mode)) {
+ if (bond_uses_primary(bond)) {
pr_info("%s: making interface %s the new active one\n",
bond->dev->name, new_active->dev->name);
}
}
}
- if (USES_PRIMARY(bond->params.mode))
+ if (bond_uses_primary(bond))
bond_hw_addr_swap(bond, new_active, old_active);
if (bond_is_lb(bond)) {
@@ -876,7 +876,7 @@
* resend only if bond is brought up with the affected
* bonding modes and the retransmission is enabled */
if (netif_running(bond->dev) && (bond->params.resend_igmp > 0) &&
- ((USES_PRIMARY(bond->params.mode) && new_active) ||
+ ((bond_uses_primary(bond) && new_active) ||
bond->params.mode == BOND_MODE_ROUNDROBIN)) {
bond->igmp_retrans = bond->params.resend_igmp;
queue_delayed_work(bond->wq, &bond->mcast_work, 1);
@@ -1381,10 +1381,10 @@
goto err_close;
}
- /* If the mode USES_PRIMARY, then the following is handled by
+ /* If the mode uses primary, then the following is handled by
* bond_change_active_slave().
*/
- if (!USES_PRIMARY(bond->params.mode)) {
+ if (!bond_uses_primary(bond)) {
/* set promiscuity level to new slave */
if (bond_dev->flags & IFF_PROMISC) {
res = dev_set_promiscuity(slave_dev, 1);
@@ -1480,7 +1480,7 @@
new_slave->link == BOND_LINK_DOWN ? "DOWN" :
(new_slave->link == BOND_LINK_UP ? "UP" : "BACK"));
- if (USES_PRIMARY(bond->params.mode) && bond->params.primary[0]) {
+ if (bond_uses_primary(bond) && bond->params.primary[0]) {
/* if there is a primary slave, remember it */
if (strcmp(bond->params.primary, new_slave->dev->name) == 0) {
bond->primary_slave = new_slave;
@@ -1569,7 +1569,7 @@
bond_compute_features(bond);
bond_set_carrier(bond);
- if (USES_PRIMARY(bond->params.mode)) {
+ if (bond_uses_primary(bond)) {
block_netpoll_tx();
write_lock_bh(&bond->curr_slave_lock);
bond_select_active_slave(bond);
@@ -1593,7 +1593,7 @@
netdev_rx_handler_unregister(slave_dev);
err_detach:
- if (!USES_PRIMARY(bond->params.mode))
+ if (!bond_uses_primary(bond))
bond_hw_addr_flush(bond_dev, slave_dev);
vlan_vids_del_by_dev(slave_dev, bond_dev);
@@ -1778,10 +1778,10 @@
/* must do this from outside any spinlocks */
vlan_vids_del_by_dev(slave_dev, bond_dev);
- /* If the mode USES_PRIMARY, then this cases was handled above by
+ /* If the mode uses primary, then this cases was handled above by
* bond_change_active_slave(..., NULL)
*/
- if (!USES_PRIMARY(bond->params.mode)) {
+ if (!bond_uses_primary(bond)) {
/* unset promiscuity level from slave
* NOTE: The NETDEV_CHANGEADDR call above may change the value
* of the IFF_PROMISC flag in the bond_dev, but we need the
@@ -2915,7 +2915,7 @@
break;
case NETDEV_CHANGENAME:
/* we don't care if we don't have primary set */
- if (!USES_PRIMARY(bond->params.mode) ||
+ if (!bond_uses_primary(bond) ||
!bond->params.primary[0])
break;
@@ -3105,7 +3105,7 @@
if (bond_has_slaves(bond)) {
read_lock(&bond->curr_slave_lock);
bond_for_each_slave(bond, slave, iter) {
- if (USES_PRIMARY(bond->params.mode)
+ if (bond_uses_primary(bond)
&& (slave != bond->curr_active_slave)) {
bond_set_slave_inactive_flags(slave,
BOND_SLAVE_NOTIFY_NOW);
@@ -3343,7 +3343,7 @@
rcu_read_lock();
- if (USES_PRIMARY(bond->params.mode)) {
+ if (bond_uses_primary(bond)) {
slave = rcu_dereference(bond->curr_active_slave);
if (slave) {
dev_uc_sync(slave->dev, bond_dev);
@@ -4268,7 +4268,7 @@
pr_debug("Warning: either miimon or arp_interval and arp_ip_target module parameters must be specified, otherwise bonding will not detect link failures! see bonding.txt for details\n");
}
- if (primary && !USES_PRIMARY(bond_mode)) {
+ if (primary && !bond_mode_uses_primary(bond_mode)) {
/* currently, using a primary only makes sense
* in active backup, TLB or ALB modes
*/