[SCSI] zfcp: Do not wait for SBALs on stopped queue
Trying to read the FC host statistics on an offline adapter results in
a 5 seconds wait. Reading the statistics tries to issue an exchange
port data request which first waits up to 5 seconds for an entry in
the request queue.
Change the strategy for getting a free SBAL to exit when the queue is
stopped. Reading the statistics will then fail without the wait.
Reviewed-by: Swen Schillig <swen@vnet.ibm.com>
Signed-off-by: Christof Schmitt <christof.schmitt@de.ibm.com>
Signed-off-by: James Bottomley <James.Bottomley@suse.de>
diff --git a/drivers/s390/scsi/zfcp_fsf.c b/drivers/s390/scsi/zfcp_fsf.c
index 4e15361..229795f 100644
--- a/drivers/s390/scsi/zfcp_fsf.c
+++ b/drivers/s390/scsi/zfcp_fsf.c
@@ -719,11 +719,6 @@
zfcp_qdio_req_init(adapter->qdio, &req->qdio_req, req->req_id, sbtype,
req->qtcb, sizeof(struct fsf_qtcb));
- if (!(atomic_read(&adapter->status) & ZFCP_STATUS_ADAPTER_QDIOUP)) {
- zfcp_fsf_req_free(req);
- return ERR_PTR(-EIO);
- }
-
return req;
}
diff --git a/drivers/s390/scsi/zfcp_qdio.c b/drivers/s390/scsi/zfcp_qdio.c
index 28117e1..6fa5e04 100644
--- a/drivers/s390/scsi/zfcp_qdio.c
+++ b/drivers/s390/scsi/zfcp_qdio.c
@@ -251,7 +251,8 @@
struct zfcp_qdio_queue *req_q = &qdio->req_q;
spin_lock_bh(&qdio->req_q_lock);
- if (atomic_read(&req_q->count))
+ if (atomic_read(&req_q->count) ||
+ !(atomic_read(&qdio->adapter->status) & ZFCP_STATUS_ADAPTER_QDIOUP))
return 1;
spin_unlock_bh(&qdio->req_q_lock);
return 0;
@@ -274,8 +275,13 @@
spin_unlock_bh(&qdio->req_q_lock);
ret = wait_event_interruptible_timeout(qdio->req_q_wq,
zfcp_qdio_sbal_check(qdio), 5 * HZ);
+
+ if (!(atomic_read(&qdio->adapter->status) & ZFCP_STATUS_ADAPTER_QDIOUP))
+ return -EIO;
+
if (ret > 0)
return 0;
+
if (!ret) {
atomic_inc(&qdio->req_q_full);
/* assume hanging outbound queue, try queue recovery */
@@ -375,6 +381,8 @@
atomic_clear_mask(ZFCP_STATUS_ADAPTER_QDIOUP, &qdio->adapter->status);
spin_unlock_bh(&qdio->req_q_lock);
+ wake_up(&qdio->req_q_wq);
+
qdio_shutdown(qdio->adapter->ccw_device,
QDIO_FLAG_CLEANUP_USING_CLEAR);