mmc: Graceful fallback for fancy features
MMC high-speed, wide bus support and SD high-speed
are functions that aren't critical for correct
operation of the card. As such, they shouldn't mark
the card as bad or dead when there is a failure
activating these features.
This is needed in particular on some really stupid
hardware (e.g. Winbond's) where not all data transfer
commands are supported.
Signed-off-by: Pierre Ossman <drzeus@drzeus.cx>
diff --git a/drivers/mmc/mmc.c b/drivers/mmc/mmc.c
index fb04bdd..5046a16 100644
--- a/drivers/mmc/mmc.c
+++ b/drivers/mmc/mmc.c
@@ -1092,7 +1092,8 @@
mmc_wait_for_req(host, &mrq);
if (cmd.error != MMC_ERR_NONE || data.error != MMC_ERR_NONE) {
- mmc_card_set_dead(card);
+ printk("%s: unable to read EXT_CSD, performance "
+ "might suffer.\n", mmc_hostname(card->host));
continue;
}
@@ -1108,7 +1109,6 @@
printk("%s: card is mmc v4 but doesn't support "
"any high-speed modes.\n",
mmc_hostname(card->host));
- mmc_card_set_bad(card);
continue;
}
@@ -1289,7 +1289,9 @@
mmc_wait_for_req(host, &mrq);
if (cmd.error != MMC_ERR_NONE || data.error != MMC_ERR_NONE) {
- mmc_card_set_dead(card);
+ printk("%s: unable to read switch capabilities, "
+ "performance might suffer.\n",
+ mmc_hostname(card->host));
continue;
}
@@ -1321,12 +1323,8 @@
mmc_wait_for_req(host, &mrq);
- if (cmd.error != MMC_ERR_NONE || data.error != MMC_ERR_NONE) {
- mmc_card_set_dead(card);
- continue;
- }
-
- if ((status[16] & 0xF) != 1) {
+ if (cmd.error != MMC_ERR_NONE || data.error != MMC_ERR_NONE ||
+ (status[16] & 0xF) != 1) {
printk(KERN_WARNING "%s: Problem switching card "
"into high-speed mode!\n",
mmc_hostname(host));