usb: phy: msm: Replace custom enum usb_mode_type with enum usb_dr_mode
Use enum usb_dr_mode and drop default usb_dr_mode from platform data.
USB DT bindings states: dr_mode: "...In case this attribute isn't
passed via DT, USB DRD controllers should default to OTG...",
so remove redundand field.
Signed-off-by: Ivan T. Ivanov <iivanov@mm-sol.com>
Acked-by: David Brown <davidb@codeaurora.org>
Signed-off-by: Felipe Balbi <balbi@ti.com>
diff --git a/include/linux/usb/msm_hsusb.h b/include/linux/usb/msm_hsusb.h
index 8705b01..72c5830 100644
--- a/include/linux/usb/msm_hsusb.h
+++ b/include/linux/usb/msm_hsusb.h
@@ -23,21 +23,6 @@
#include <linux/clk.h>
/**
- * Supported USB modes
- *
- * USB_PERIPHERAL Only peripheral mode is supported.
- * USB_HOST Only host mode is supported.
- * USB_OTG OTG mode is supported.
- *
- */
-enum usb_mode_type {
- USB_NONE = 0,
- USB_PERIPHERAL,
- USB_HOST,
- USB_OTG,
-};
-
-/**
* OTG control
*
* OTG_NO_CONTROL Id/VBUS notifications not required. Useful in host
@@ -121,8 +106,6 @@
* @power_budget: VBUS power budget in mA (0 will be treated as 500mA).
* @mode: Supported mode (OTG/peripheral/host).
* @otg_control: OTG switch controlled by user/Id pin
- * @default_mode: Default operational mode. Applicable only if
- * OTG switch is controller by user.
* @pclk_src_name: pclk is derived from ebi1_usb_clk in case of 7x27 and 8k
* dfab_usb_hs_clk in case of 8660 and 8960.
*/
@@ -130,9 +113,8 @@
int *phy_init_seq;
void (*vbus_power)(bool on);
unsigned power_budget;
- enum usb_mode_type mode;
+ enum usb_dr_mode mode;
enum otg_control_type otg_control;
- enum usb_mode_type default_mode;
enum msm_usb_phy_type phy_type;
void (*setup_gpio)(enum usb_otg_state state);
char *pclk_src_name;