diff --git a/Documentation/RCU/torture.txt b/Documentation/RCU/torture.txt
index 02b3d14..516527d 100644
--- a/Documentation/RCU/torture.txt
+++ b/Documentation/RCU/torture.txt
@@ -10,13 +10,20 @@
 command (perhaps grepping for "torture").  The test is started
 when the module is loaded, and stops when the module is unloaded.
 
-However, actually setting this config option to "y" results in the system
-running the test immediately upon boot, and ending only when the system
-is taken down.  Normally, one will instead want to build the system
-with CONFIG_RCU_TORTURE_TEST=m and to use modprobe and rmmod to control
-the test, perhaps using a script similar to the one shown at the end of
-this document.  Note that you will need CONFIG_MODULE_UNLOAD in order
-to be able to end the test.
+CONFIG_RCU_TORTURE_TEST_RUNNABLE
+
+It is also possible to specify CONFIG_RCU_TORTURE_TEST=y, which will
+result in the tests being loaded into the base kernel.  In this case,
+the CONFIG_RCU_TORTURE_TEST_RUNNABLE config option is used to specify
+whether the RCU torture tests are to be started immediately during
+boot or whether the /proc/sys/kernel/rcutorture_runnable file is used
+to enable them.  This /proc file can be used to repeatedly pause and
+restart the tests, regardless of the initial state specified by the
+CONFIG_RCU_TORTURE_TEST_RUNNABLE config option.
+
+You will normally -not- want to start the RCU torture tests during boot
+(and thus the default is CONFIG_RCU_TORTURE_TEST_RUNNABLE=n), but doing
+this can sometimes be useful in finding boot-time bugs.
 
 
 MODULE PARAMETERS