scsi: ufs: fix condition in which DME command failure msg is printed out
The condition in which error message is printed out was incorrect and
resulted error message only if retries exhausted.
But retries happens only if DME command is a peer command, and thus
DME commands which are not peer commands and fail are not printed out.
This change fixes this issue.
Signed-off-by: Yaniv Gardi <ygardi@codeaurora.org>
Signed-off-by: Subhash Jadavani <subhashj@codeaurora.org>
Signed-off-by: Martin K. Petersen <martin.petersen@oracle.com>
diff --git a/drivers/scsi/ufs/ufshcd.c b/drivers/scsi/ufs/ufshcd.c
index ec4c99a..b826078 100644
--- a/drivers/scsi/ufs/ufshcd.c
+++ b/drivers/scsi/ufs/ufshcd.c
@@ -2516,10 +2516,10 @@ int ufshcd_dme_set_attr(struct ufs_hba *hba, u32 attr_sel,
set, UIC_GET_ATTR_ID(attr_sel), mib_val, ret);
} while (ret && peer && --retries);
- if (!retries)
+ if (ret)
dev_err(hba->dev, "%s: attr-id 0x%x val 0x%x failed %d retries\n",
- set, UIC_GET_ATTR_ID(attr_sel), mib_val,
- retries);
+ set, UIC_GET_ATTR_ID(attr_sel), mib_val,
+ UFS_UIC_COMMAND_RETRIES - retries);
return ret;
}
@@ -2583,9 +2583,10 @@ int ufshcd_dme_get_attr(struct ufs_hba *hba, u32 attr_sel,
get, UIC_GET_ATTR_ID(attr_sel), ret);
} while (ret && peer && --retries);
- if (!retries)
+ if (ret)
dev_err(hba->dev, "%s: attr-id 0x%x failed %d retries\n",
- get, UIC_GET_ATTR_ID(attr_sel), retries);
+ get, UIC_GET_ATTR_ID(attr_sel),
+ UFS_UIC_COMMAND_RETRIES - retries);
if (mib_val && !ret)
*mib_val = uic_cmd.argument3;