batman-adv: Use rtnl link in device creation example
The standard kernel API to add new virtual interfaces and attach other
interfaces to it is rtnl-link. batman-adv supports it since v3.10. This
functionality should be used instead of the legacy batman-adv-only sysfs
interface.
Signed-off-by: Sven Eckelmann <sven@narfation.org>
Signed-off-by: Marek Lindner <mareklindner@neomailbox.ch>
Signed-off-by: Simon Wunderlich <sw@simonwunderlich.de>
diff --git a/Documentation/networking/batman-adv.txt b/Documentation/networking/batman-adv.txt
index 1b5e7a7..8a8d3d9 100644
--- a/Documentation/networking/batman-adv.txt
+++ b/Documentation/networking/batman-adv.txt
@@ -43,10 +43,15 @@
reload the module if you plug your USB wifi adapter into your ma-
chine after batman advanced was initially loaded.
-To activate a given interface simply write "bat0" into its
-"mesh_iface" file inside the batman_adv subfolder:
+The batman-adv soft-interface can be created using the iproute2
+tool "ip"
-# echo bat0 > /sys/class/net/eth0/batman_adv/mesh_iface
+# ip link add name bat0 type batadv
+
+To activate a given interface simply attach it to the "bat0"
+interface
+
+# ip link set dev eth0 master bat0
Repeat this step for all interfaces you wish to add. Now batman
starts using/broadcasting on this/these interface(s).
@@ -56,10 +61,10 @@
# cat /sys/class/net/eth0/batman_adv/iface_status
# active
-To deactivate an interface you have to write "none" into its
-"mesh_iface" file:
+To deactivate an interface you have to detach it from the
+"bat0" interface:
-# echo none > /sys/class/net/eth0/batman_adv/mesh_iface
+# ip link set dev eth0 nomaster
All mesh wide settings can be found in batman's own interface