pci root complex: support for tile architecture
This change enables PCI root complex support for TILEPro. Unlike
TILE-Gx, TILEPro has no support for memory-mapped I/O, so the PCI
support consists of hypervisor upcalls for PIO, DMA, etc. However,
the performance is fine for the devices we have tested with so far
(1Gb Ethernet, SATA, etc.).
The <asm/io.h> header was tweaked to be a little bit more aggressive
about disabling attempts to map/unmap IO port space. The hacky
<asm/pci-bridge.h> header was rolled into the <asm/pci.h> header
and the result was simplified. Both of the latter two headers were
preliminary versions not meant for release before now - oh well.
There is one quirk for our TILEmpower platform, which accidentally
negotiates up to 5GT and needs to be kicked down to 2.5GT.
Signed-off-by: Chris Metcalf <cmetcalf@tilera.com>
diff --git a/drivers/pci/quirks.c b/drivers/pci/quirks.c
index f5c63fe..6f9350c 100644
--- a/drivers/pci/quirks.c
+++ b/drivers/pci/quirks.c
@@ -2136,6 +2136,24 @@
DECLARE_PCI_FIXUP_EARLY(PCI_VENDOR_ID_INTEL, PCI_DEVICE_ID_INTEL_82875_HB,
quirk_unhide_mch_dev6);
+#ifdef CONFIG_TILE
+/*
+ * The Tilera TILEmpower platform needs to set the link speed
+ * to 2.5GT(Giga-Transfers)/s (Gen 1). The default link speed
+ * setting is 5GT/s (Gen 2). 0x98 is the Link Control2 PCIe
+ * capability register of the PEX8624 PCIe switch. The switch
+ * supports link speed auto negotiation, but falsely sets
+ * the link speed to 5GT/s.
+ */
+static void __devinit quirk_tile_plx_gen1(struct pci_dev *dev)
+{
+ if (tile_plx_gen1) {
+ pci_write_config_dword(dev, 0x98, 0x1);
+ mdelay(50);
+ }
+}
+DECLARE_PCI_FIXUP_EARLY(PCI_VENDOR_ID_PLX, 0x8624, quirk_tile_plx_gen1);
+#endif /* CONFIG_TILE */
#ifdef CONFIG_PCI_MSI
/* Some chipsets do not support MSI. We cannot easily rely on setting