wil6210: enable scan while connected
New firmware do support scan while connected. Enable it.
Signed-off-by: Vladimir Kondratiev <qca_vkondrat@qca.qualcomm.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/drivers/net/wireless/ath/wil6210/cfg80211.c b/drivers/net/wireless/ath/wil6210/cfg80211.c
index 7439303..b1bc007 100644
--- a/drivers/net/wireless/ath/wil6210/cfg80211.c
+++ b/drivers/net/wireless/ath/wil6210/cfg80211.c
@@ -282,7 +282,7 @@
/* FW don't support scan after connection attempt */
if (test_bit(wil_status_dontscan, &wil->status)) {
- wil_err(wil, "Scan after connect attempt not supported\n");
+ wil_err(wil, "Can't scan now\n");
return -EBUSY;
}
@@ -402,10 +402,7 @@
memcpy(conn.bssid, bss->bssid, ETH_ALEN);
memcpy(conn.dst_mac, bss->bssid, ETH_ALEN);
- /*
- * FW don't support scan after connection attempt
- */
- set_bit(wil_status_dontscan, &wil->status);
+
set_bit(wil_status_fwconnecting, &wil->status);
rc = wmi_send(wil, WMI_CONNECT_CMDID, &conn, sizeof(conn));
@@ -414,7 +411,6 @@
mod_timer(&wil->connect_timer,
jiffies + msecs_to_jiffies(2000));
} else {
- clear_bit(wil_status_dontscan, &wil->status);
clear_bit(wil_status_fwconnecting, &wil->status);
}
diff --git a/drivers/net/wireless/ath/wil6210/main.c b/drivers/net/wireless/ath/wil6210/main.c
index f10a0b2..4cc1b78 100644
--- a/drivers/net/wireless/ath/wil6210/main.c
+++ b/drivers/net/wireless/ath/wil6210/main.c
@@ -113,8 +113,6 @@
GFP_KERNEL);
}
clear_bit(wil_status_fwconnecting, &wil->status);
- wil_dbg_misc(wil, "clear_bit(wil_status_dontscan)\n");
- clear_bit(wil_status_dontscan, &wil->status);
break;
default:
/* AP-like interface and monitor: