usb: musb: Start using struct usb_otg
Use struct usb_otg members with OTG specific functions instead
of usb_phy members.
[ balbi@ti.com: added a missing change on musb_gadget.c to avoid
a compile error on a later patch ]
Signed-off-by: Heikki Krogerus <heikki.krogerus@linux.intel.com>
Reviewed-by: Marek Vasut <marek.vasut@gmail.com>
Signed-off-by: Felipe Balbi <balbi@ti.com>
diff --git a/drivers/usb/musb/am35x.c b/drivers/usb/musb/am35x.c
index e233d2b..cb942b6 100644
--- a/drivers/usb/musb/am35x.c
+++ b/drivers/usb/musb/am35x.c
@@ -226,6 +226,7 @@
struct device *dev = musb->controller;
struct musb_hdrc_platform_data *plat = dev->platform_data;
struct omap_musb_board_data *data = plat->board_data;
+ struct usb_otg *otg = musb->xceiv->otg;
unsigned long flags;
irqreturn_t ret = IRQ_NONE;
u32 epintr, usbintr;
@@ -289,14 +290,14 @@
WARNING("VBUS error workaround (delay coming)\n");
} else if (is_host_enabled(musb) && drvvbus) {
MUSB_HST_MODE(musb);
- musb->xceiv->default_a = 1;
+ otg->default_a = 1;
musb->xceiv->state = OTG_STATE_A_WAIT_VRISE;
portstate(musb->port1_status |= USB_PORT_STAT_POWER);
del_timer(&otg_workaround);
} else {
musb->is_active = 0;
MUSB_DEV_MODE(musb);
- musb->xceiv->default_a = 0;
+ otg->default_a = 0;
musb->xceiv->state = OTG_STATE_B_IDLE;
portstate(musb->port1_status &= ~USB_PORT_STAT_POWER);
}