serial: exar: Leave MPIOs as output for Commtech adapters
Commtech adapters apparently need the original setting as outputs, see
https://marc.info/?l=linux-gpio&m=149557425201323&w=2. Account for that.
Fixes: 7dea8165f1d6 ("serial: exar: Preconfigure xr17v35x MPIOs as output")
Signed-off-by: Jan Kiszka <jan.kiszka@siemens.com>
Reviewed-by: Andy Shevchenko <andy.shevchenko@gmail.com>
Reviewed-by: Linus Walleij <linus.walleij@linaro.org>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
diff --git a/drivers/tty/serial/8250/8250_exar.c b/drivers/tty/serial/8250/8250_exar.c
index 0a20f71..a309bcf 100644
--- a/drivers/tty/serial/8250/8250_exar.c
+++ b/drivers/tty/serial/8250/8250_exar.c
@@ -170,19 +170,26 @@
return default_setup(priv, pcidev, idx, offset, port);
}
-static void setup_gpio(u8 __iomem *p)
+static void setup_gpio(struct pci_dev *pcidev, u8 __iomem *p)
{
+ /*
+ * The Commtech adapters required the MPIOs to be driven low. The Exar
+ * devices will export them as GPIOs, so we pre-configure them safely
+ * as inputs.
+ */
+ u8 dir = pcidev->vendor == PCI_VENDOR_ID_EXAR ? 0xff : 0x00;
+
writeb(0x00, p + UART_EXAR_MPIOINT_7_0);
writeb(0x00, p + UART_EXAR_MPIOLVL_7_0);
writeb(0x00, p + UART_EXAR_MPIO3T_7_0);
writeb(0x00, p + UART_EXAR_MPIOINV_7_0);
- writeb(0xff, p + UART_EXAR_MPIOSEL_7_0);
+ writeb(dir, p + UART_EXAR_MPIOSEL_7_0);
writeb(0x00, p + UART_EXAR_MPIOOD_7_0);
writeb(0x00, p + UART_EXAR_MPIOINT_15_8);
writeb(0x00, p + UART_EXAR_MPIOLVL_15_8);
writeb(0x00, p + UART_EXAR_MPIO3T_15_8);
writeb(0x00, p + UART_EXAR_MPIOINV_15_8);
- writeb(0xff, p + UART_EXAR_MPIOSEL_15_8);
+ writeb(dir, p + UART_EXAR_MPIOSEL_15_8);
writeb(0x00, p + UART_EXAR_MPIOOD_15_8);
}
@@ -235,7 +242,7 @@
if (idx == 0) {
/* Setup Multipurpose Input/Output pins. */
- setup_gpio(p);
+ setup_gpio(pcidev, p);
port->port.private_data = xr17v35x_register_gpio(pcidev);
}