atmel_spi: remove unnecessary (and wrong) #ifdefs
Now that the cpu_is_xxx() macros are available both on AVR32 and AT91, we can
remove a couple of #ifdefs from this driver. One of them is actually wrong --
new_1 should be set on AVR32 but isn't. This causes the bus clock to run at
twice the speed it is configured to.
Signed-off-by: Haavard Skinnemoen <hskinnemoen@atmel.com>
Cc: David Brownell <david-b@pacbell.net>
Acked-by: Andrew Victor <andrew@sanpeople.com>
Cc: Nicolas Ferre <nicolas.ferre@rfo.atmel.com>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
diff --git a/drivers/spi/atmel_spi.c b/drivers/spi/atmel_spi.c
index 66e7bc9..1d8a2f6 100644
--- a/drivers/spi/atmel_spi.c
+++ b/drivers/spi/atmel_spi.c
@@ -22,10 +22,7 @@
#include <asm/io.h>
#include <asm/arch/board.h>
#include <asm/arch/gpio.h>
-
-#ifdef CONFIG_ARCH_AT91
#include <asm/arch/cpu.h>
-#endif
#include "atmel_spi.h"
@@ -552,10 +549,8 @@
goto out_free_buffer;
as->irq = irq;
as->clk = clk;
-#ifdef CONFIG_ARCH_AT91
if (!cpu_is_at91rm9200())
as->new_1 = 1;
-#endif
ret = request_irq(irq, atmel_spi_interrupt, 0,
pdev->dev.bus_id, master);