tg3: Fix io failures after chip reset
Commit f2096f94b514d88593355995d5dd276961e88af1, entitled
"tg3: Add 5720 H2BMC support", needed to add code to preserve some bits
set by firmware. Unfortunately the new code causes throughput to stop
after a chip reset because it enables state machines before they are
ready. This patch undoes the problematic code. The bits will be
restored later in the init sequence.
Signed-off-by: Matt Carlson <mcarlson@broadcom.com>
Reviewed-by: Michael Chan <mchan@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/tg3.c b/drivers/net/tg3.c
index a5ff82d..5bf7671 100644
--- a/drivers/net/tg3.c
+++ b/drivers/net/tg3.c
@@ -7412,16 +7412,11 @@
tw32(TG3PCI_CLOCK_CTRL, tp->pci_clock_ctrl);
}
- if (tg3_flag(tp, ENABLE_APE))
- tp->mac_mode = MAC_MODE_APE_TX_EN |
- MAC_MODE_APE_RX_EN |
- MAC_MODE_TDE_ENABLE;
-
if (tp->phy_flags & TG3_PHYFLG_PHY_SERDES) {
- tp->mac_mode |= MAC_MODE_PORT_MODE_TBI;
+ tp->mac_mode = MAC_MODE_PORT_MODE_TBI;
val = tp->mac_mode;
} else if (tp->phy_flags & TG3_PHYFLG_MII_SERDES) {
- tp->mac_mode |= MAC_MODE_PORT_MODE_GMII;
+ tp->mac_mode = MAC_MODE_PORT_MODE_GMII;
val = tp->mac_mode;
} else
val = 0;
@@ -8559,12 +8554,11 @@
udelay(10);
}
- if (tg3_flag(tp, ENABLE_APE))
- tp->mac_mode = MAC_MODE_APE_TX_EN | MAC_MODE_APE_RX_EN;
- else
- tp->mac_mode = 0;
tp->mac_mode |= MAC_MODE_TXSTAT_ENABLE | MAC_MODE_RXSTAT_ENABLE |
- MAC_MODE_TDE_ENABLE | MAC_MODE_RDE_ENABLE | MAC_MODE_FHDE_ENABLE;
+ MAC_MODE_TDE_ENABLE | MAC_MODE_RDE_ENABLE |
+ MAC_MODE_FHDE_ENABLE;
+ if (tg3_flag(tp, ENABLE_APE))
+ tp->mac_mode |= MAC_MODE_APE_TX_EN | MAC_MODE_APE_RX_EN;
if (!tg3_flag(tp, 5705_PLUS) &&
!(tp->phy_flags & TG3_PHYFLG_PHY_SERDES) &&
GET_ASIC_REV(tp->pci_chip_rev_id) != ASIC_REV_5700)