OMAP: DSS2: Introduce omap_channel argument to DISPC functions used by interface drivers
The interface drivers (dsi.c, sdi.c etc) need to call dispc functions with
dssdev->manager->id as a parameter to specify the DISPC channel which they want
to configure/use, this is required as the same functions are now used to configure
dispc registers of different channels.
The following dispc functions are changed to incorporate channel as an argument:
-dispc_enable_fifohandcheck()
-dispc_set_lcd_size()
-dispc_set_parallel_interface_mode()
-dispc_set_tft_data_lines()
-dispc_set_lcd_display_type()
-dispc_set_lcd_timings()
Signed-off-by: Sumit Semwal <sumit.semwal@ti.com>
Signed-off-by: Mukund Mittal <mmittal@ti.com>
Signed-off-by: Samreen <samreen@ti.com>
Signed-off-by: Archit Taneja <archit@ti.com>
[tomi.valkeinen@nokia.com: fixed trivial compile error]
Signed-off-by: Tomi Valkeinen <tomi.valkeinen@nokia.com>
diff --git a/drivers/video/omap2/dss/sdi.c b/drivers/video/omap2/dss/sdi.c
index ee07a3c..19443b1 100644
--- a/drivers/video/omap2/dss/sdi.c
+++ b/drivers/video/omap2/dss/sdi.c
@@ -35,12 +35,16 @@
struct regulator *vdds_sdi_reg;
} sdi;
-static void sdi_basic_init(void)
-{
- dispc_set_parallel_interface_mode(OMAP_DSS_PARALLELMODE_BYPASS);
+static void sdi_basic_init(struct omap_dss_device *dssdev)
- dispc_set_lcd_display_type(OMAP_DSS_LCD_DISPLAY_TFT);
- dispc_set_tft_data_lines(24);
+{
+ dispc_set_parallel_interface_mode(dssdev->manager->id,
+ OMAP_DSS_PARALLELMODE_BYPASS);
+
+ dispc_set_lcd_display_type(dssdev->manager->id,
+ OMAP_DSS_LCD_DISPLAY_TFT);
+
+ dispc_set_tft_data_lines(dssdev->manager->id, 24);
dispc_lcd_enable_signal_polarity(1);
}
@@ -68,7 +72,7 @@
if (!sdi.skip_init)
dss_clk_enable(DSS_CLK_ICK | DSS_CLK_FCK1);
- sdi_basic_init();
+ sdi_basic_init(dssdev);
/* 15.5.9.1.2 */
dssdev->panel.config |= OMAP_DSS_LCD_RF | OMAP_DSS_LCD_ONOFF;
@@ -102,7 +106,7 @@
}
- dispc_set_lcd_timings(t);
+ dispc_set_lcd_timings(dssdev->manager->id, t);
r = dss_set_clock_div(&dss_cinfo);
if (r)