ARM: at91/boards: use -EINVAL for invalid gpio
this will allow to use gpio_is_valid
Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
Cc: Nicolas Ferre <nicolas.ferre@atmel.com>
diff --git a/arch/arm/mach-at91/board-stamp9g20.c b/arch/arm/mach-at91/board-stamp9g20.c
index f4b9b6f..e8d3d5b 100644
--- a/arch/arm/mach-at91/board-stamp9g20.c
+++ b/arch/arm/mach-at91/board-stamp9g20.c
@@ -85,6 +85,7 @@
.rdy_pin = AT91_PIN_PC13,
.enable_pin = AT91_PIN_PC14,
.bus_width_16 = 0,
+ .det_pin = -EINVAL,
};
static struct sam9_smc_config __initdata nand_smc_config = {
@@ -122,12 +123,17 @@
static struct mci_platform_data __initdata mmc_data = {
.slot[0] = {
.bus_width = 4,
+ .detect_pin = -1;
+ .wp_pin = -1;
},
};
#else
static struct at91_mmc_data __initdata mmc_data = {
.slot_b = 0,
.wire4 = 1,
+ .det_pin = -EINVAL,
+ .wp_pin = -EINVAL,
+ .vcc_pin = -EINVAL,
};
#endif
@@ -137,6 +143,8 @@
*/
static struct at91_usbh_data __initdata usbh_data = {
.ports = 2,
+ .vbus_pin = {-EINVAL, -EINVAL},
+ .overcurrent_pin= {-EINVAL, -EINVAL},
};
@@ -145,12 +153,12 @@
*/
static struct at91_udc_data __initdata portuxg20_udc_data = {
.vbus_pin = AT91_PIN_PC7,
- .pullup_pin = 0, /* pull-up driven by UDC */
+ .pullup_pin = -EINVAL, /* pull-up driven by UDC */
};
static struct at91_udc_data __initdata stamp9g20evb_udc_data = {
.vbus_pin = AT91_PIN_PA22,
- .pullup_pin = 0, /* pull-up driven by UDC */
+ .pullup_pin = -EINVAL, /* pull-up driven by UDC */
};