diff --git a/include/linux/nl80211.h b/include/linux/nl80211.h
index d2f276d..45db17f 100644
--- a/include/linux/nl80211.h
+++ b/include/linux/nl80211.h
@@ -160,6 +160,11 @@
  * @NL80211_CMD_SCAN_ABORTED: scan was aborted, for unspecified reasons,
  *	partial scan results may be available
  *
+ * @NL80211_CMD_GET_SURVEY: get survey resuls, e.g. channel occupation
+ *      or noise level
+ * @NL80211_CMD_NEW_SURVEY_RESULTS: survey data notification (as a reply to
+ *	NL80211_CMD_GET_SURVEY and on the "scan" multicast group)
+ *
  * @NL80211_CMD_REG_CHANGE: indicates to userspace the regulatory domain
  * 	has been changed and provides details of the request information
  * 	that caused the change such as who initiated the regulatory request
@@ -341,6 +346,9 @@
 
 	NL80211_CMD_SET_WIPHY_NETNS,
 
+	NL80211_CMD_GET_SURVEY,
+	NL80211_CMD_NEW_SURVEY_RESULTS,
+
 	/* add new commands above here */
 
 	/* used to define NL80211_CMD_MAX below */
@@ -586,6 +594,10 @@
  *
  * @NL80211_ATTR_4ADDR: Use 4-address frames on a virtual interface
  *
+ * @NL80211_ATTR_SURVEY_INFO: survey information about a channel, part of
+ *      the survey response for %NL80211_CMD_GET_SURVEY, nested attribute
+ *      containing info as possible, see &enum survey_info.
+ *
  * @NL80211_ATTR_MAX: highest attribute number currently defined
  * @__NL80211_ATTR_AFTER_LAST: internal use
  */
@@ -718,6 +730,8 @@
 
 	NL80211_ATTR_4ADDR,
 
+	NL80211_ATTR_SURVEY_INFO,
+
 	/* add attributes here, update the policy in nl80211.c */
 
 	__NL80211_ATTR_AFTER_LAST,
@@ -1121,6 +1135,26 @@
 };
 
 /**
+ * enum nl80211_survey_info - survey information
+ *
+ * These attribute types are used with %NL80211_ATTR_SURVEY_INFO
+ * when getting information about a survey.
+ *
+ * @__NL80211_SURVEY_INFO_INVALID: attribute number 0 is reserved
+ * @NL80211_SURVEY_INFO_FREQUENCY: center frequency of channel
+ * @NL80211_SURVEY_INFO_NOISE: noise level of channel (u8, dBm)
+ */
+enum nl80211_survey_info {
+	__NL80211_SURVEY_INFO_INVALID,
+	NL80211_SURVEY_INFO_FREQUENCY,
+	NL80211_SURVEY_INFO_NOISE,
+
+	/* keep last */
+	__NL80211_SURVEY_INFO_AFTER_LAST,
+	NL80211_SURVEY_INFO_MAX = __NL80211_SURVEY_INFO_AFTER_LAST - 1
+};
+
+/**
  * enum nl80211_mntr_flags - monitor configuration flags
  *
  * Monitor configuration flags.
diff --git a/include/net/cfg80211.h b/include/net/cfg80211.h
index 0e4c51f..21710fc 100644
--- a/include/net/cfg80211.h
+++ b/include/net/cfg80211.h
@@ -235,6 +235,35 @@
 };
 
 /**
+ * enum survey_info_flags - survey information flags
+ *
+ * Used by the driver to indicate which info in &struct survey_info
+ * it has filled in during the get_survey().
+ */
+enum survey_info_flags {
+	SURVEY_INFO_NOISE_DBM = 1<<0,
+};
+
+/**
+ * struct survey_info - channel survey response
+ *
+ * Used by dump_survey() to report back per-channel survey information.
+ *
+ * @channel: the channel this survey record reports, mandatory
+ * @filled: bitflag of flags from &enum survey_info_flags
+ * @noise: channel noise in dBm. This and all following fields are
+ *     optional
+ *
+ * This structure can later be expanded with things like
+ * channel duty cycle etc.
+ */
+struct survey_info {
+	struct ieee80211_channel *channel;
+	u32 filled;
+	s8 noise;
+};
+
+/**
  * struct beacon_parameters - beacon parameters
  *
  * Used to configure the beacon for an interface.
@@ -944,6 +973,8 @@
  * @rfkill_poll: polls the hw rfkill line, use cfg80211 reporting
  *	functions to adjust rfkill hw state
  *
+ * @dump_survey: get site survey information.
+ *
  * @testmode_cmd: run a test mode command
  */
 struct cfg80211_ops {
@@ -1063,6 +1094,9 @@
 				    const u8 *peer,
 				    const struct cfg80211_bitrate_mask *mask);
 
+	int	(*dump_survey)(struct wiphy *wiphy, struct net_device *netdev,
+			int idx, struct survey_info *info);
+
 	/* some temporary stuff to finish wext */
 	int	(*set_power_mgmt)(struct wiphy *wiphy, struct net_device *dev,
 				  bool enabled, int timeout);