bnx2x: Initialize cnic status block during chip reset
When the device is reset during MTU change, ring size change, or self
test, etc, the cnic status block needs to be properly initialized if
cnic is registered.
Signed-off-by: Michael Chan <mchan@broadcom.com>
Signed-off-by: Eilon Greenstein <eilong@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/bnx2x_main.c b/drivers/net/bnx2x_main.c
index 77ba135..306c2b8 100644
--- a/drivers/net/bnx2x_main.c
+++ b/drivers/net/bnx2x_main.c
@@ -7593,6 +7593,8 @@
if (bp->cnic_eth_dev.drv_state & CNIC_DRV_STATE_REGD) {
bnx2x_set_iscsi_eth_mac_addr(bp, 1);
bp->cnic_flags |= BNX2X_CNIC_FLAG_MAC_SET;
+ bnx2x_init_sb(bp, bp->cnic_sb, bp->cnic_sb_mapping,
+ CNIC_SB_ID(bp));
}
mutex_unlock(&bp->cnic_mutex);
#endif