ide: filter out "default" transfer mode values in set_xfer_rate()

* Filter out "default" transfer mode values (0x00 - default PIO mode,
  0x01 - default PIO mode w/ IORDY disabled) in write handler for obsoleted
  /proc/ide/hd?/settings:current_speed setting.

  Allowing "default" transfer mode values is a dangerous thing to do as
  we don't support programming controller to the "default" transfer mode
  and devices often use different values for the default and maximum PIO
  mode (i.e. PIO2 default and PIO4 maximum) so the controller will stay
  programmed for higher PIO mode while device will use the lower PIO mode.

  There is no functionality loss as by using special IOCTLs device can
  still be programmed to "default" transfer modes (it is only useful for
  debugging/testing purposes anyway).

* Remove no longer needed IDE_HFLAG_ABUSE_SET_DMA_MODE host flag, it was
  previously used by few host drivers to program the controller to PIO0
  timings for "default" transfer mode == 0x01 (although some host drivers
  would program invalid PIO timings instead).

* Cleanup ide_set_xfer_rate() and add BUG_ON().

Suggested-by: Sergei Shtylyov <sshtylyov@ru.mvista.com>
Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>
diff --git a/drivers/ide/pci/tc86c001.c b/drivers/ide/pci/tc86c001.c
index a81d47c..477e197 100644
--- a/drivers/ide/pci/tc86c001.c
+++ b/drivers/ide/pci/tc86c001.c
@@ -206,8 +206,7 @@
 	.init_hwif	= init_hwif_tc86c001,
 	.port_ops	= &tc86c001_port_ops,
 	.dma_ops	= &tc86c001_dma_ops,
-	.host_flags	= IDE_HFLAG_SINGLE | IDE_HFLAG_OFF_BOARD |
-			  IDE_HFLAG_ABUSE_SET_DMA_MODE,
+	.host_flags	= IDE_HFLAG_SINGLE | IDE_HFLAG_OFF_BOARD,
 	.pio_mask	= ATA_PIO4,
 	.mwdma_mask	= ATA_MWDMA2,
 	.udma_mask	= ATA_UDMA4,