sdhci: only reprogram retuning timer when flag is set
When the host->tuning_count is zero it means that the retuning is
disabled. This is checked on the first run of sdhci_execute_tuning()
by the if statement below:
if (!(host->flags & SDHCI_NEEDS_RETUNING) && host->tuning_count &&
(host->tuning_mode == SDHCI_TUNING_MODE_1)) {
So only when tuning_count is non-zero it will set the host flag
SDHCI_USING_RETUNING_TIMER. The else statement is only for re-programming
the timer, which means that flag must be set. Because that is not checked
the else statement is executed in the first run when tuning_count is zero.
This was seen on a host controller which indicated SDHCI_TUNING_MODE_1 (0)
and tuning_count being zero. Suspect that (one of) these registers is not
properly set.
Signed-off-by: Arend van Spriel <arend@broadcom.com>
Acked-by: Ulf Hansson <ulf.hansson@linaro.org>
Reviewed-by: Aaron Lu <aaron.lu@intel.com>
Signed-off-by: Chris Ball <chris@printf.net>
diff --git a/drivers/mmc/host/sdhci.c b/drivers/mmc/host/sdhci.c
index 04a5e25..9a79fc4 100644
--- a/drivers/mmc/host/sdhci.c
+++ b/drivers/mmc/host/sdhci.c
@@ -2026,12 +2026,11 @@
host->tuning_count * HZ);
/* Tuning mode 1 limits the maximum data length to 4MB */
mmc->max_blk_count = (4 * 1024 * 1024) / mmc->max_blk_size;
- } else {
+ } else if (host->flags & SDHCI_USING_RETUNING_TIMER) {
host->flags &= ~SDHCI_NEEDS_RETUNING;
/* Reload the new initial value for timer */
- if (host->tuning_mode == SDHCI_TUNING_MODE_1)
- mod_timer(&host->tuning_timer, jiffies +
- host->tuning_count * HZ);
+ mod_timer(&host->tuning_timer, jiffies +
+ host->tuning_count * HZ);
}
/*