powerpc/eeh: Make the delay for PE reset unified
Basically, we have 3 types of resets to fulfil PE reset: fundamental,
hot and PHB reset. For the later 2 cases, we need PCI bus reset hold
and settlement delay as specified by PCI spec. PowerNV and pSeries
platforms are running on top of different firmware and some of the
delays have been covered by underly firmware (PowerNV).
The patch makes the delays unified to be done in backend, instead of
EEH core.
Signed-off-by: Gavin Shan <gwshan@linux.vnet.ibm.com>
Signed-off-by: Benjamin Herrenschmidt <benh@kernel.crashing.org>
diff --git a/arch/powerpc/platforms/powernv/eeh-ioda.c b/arch/powerpc/platforms/powernv/eeh-ioda.c
index 0844e00..268cd46 100644
--- a/arch/powerpc/platforms/powernv/eeh-ioda.c
+++ b/arch/powerpc/platforms/powernv/eeh-ioda.c
@@ -417,9 +417,13 @@
/*
* Poll state of the PHB until the request is done
- * successfully.
+ * successfully. The PHB reset is usually PHB complete
+ * reset followed by hot reset on root bus. So we also
+ * need the PCI bus settlement delay.
*/
rc = ioda_eeh_phb_poll(phb);
+ if (option == EEH_RESET_DEACTIVATE)
+ msleep(EEH_PE_RST_SETTLE_TIME);
out:
if (rc != OPAL_SUCCESS)
return -EIO;
@@ -457,6 +461,8 @@
/* Poll state of the PHB until the request is done */
rc = ioda_eeh_phb_poll(phb);
+ if (option == EEH_RESET_DEACTIVATE)
+ msleep(EEH_PE_RST_SETTLE_TIME);
out:
if (rc != OPAL_SUCCESS)
return -EIO;
@@ -480,11 +486,15 @@
eeh_ops->read_config(dn, PCI_BRIDGE_CONTROL, 2, &ctrl);
ctrl |= PCI_BRIDGE_CTL_BUS_RESET;
eeh_ops->write_config(dn, PCI_BRIDGE_CONTROL, 2, ctrl);
+
+ msleep(EEH_PE_RST_HOLD_TIME);
break;
case EEH_RESET_DEACTIVATE:
eeh_ops->read_config(dn, PCI_BRIDGE_CONTROL, 2, &ctrl);
ctrl &= ~PCI_BRIDGE_CTL_BUS_RESET;
eeh_ops->write_config(dn, PCI_BRIDGE_CONTROL, 2, ctrl);
+
+ msleep(EEH_PE_RST_SETTLE_TIME);
break;
}