tg3: Prevent tx BD corruption
This patch prevents a tx BD corruption bug by preventing the device from
powering down the PLL from L1 if the link speed is 10Mbps or 100Mbps.
The same bits are also used to prevent a system hang during chip reset
resulting from a complicated set of events that ultimately leads to
PCIe block register corruption.
Signed-off-by: Matt Carlson <mcarlson@broadcom.com>
Reviewed-by: Michael Chan <mchan@broadcom.com>
Reviewed-by: Benjamin Li <benli@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/tg3.c b/drivers/net/tg3.c
index e8def28..595ddf2 100644
--- a/drivers/net/tg3.c
+++ b/drivers/net/tg3.c
@@ -3167,6 +3167,15 @@
pci_write_config_word(tp->pdev,
tp->pcie_cap + PCI_EXP_LNKCTL,
newlnkctl);
+ } else if (tp->tg3_flags3 & TG3_FLG3_TOGGLE_10_100_L1PLLPD) {
+ u32 newreg, oldreg = tr32(TG3_PCIE_LNKCTL);
+ if (tp->link_config.active_speed == SPEED_100 ||
+ tp->link_config.active_speed == SPEED_10)
+ newreg = oldreg & ~TG3_PCIE_LNKCTL_L1_PLL_PD_EN;
+ else
+ newreg = oldreg | TG3_PCIE_LNKCTL_L1_PLL_PD_EN;
+ if (newreg != oldreg)
+ tw32(TG3_PCIE_LNKCTL, newreg);
}
if (current_link_up != netif_carrier_ok(tp->dev)) {
@@ -6160,6 +6169,11 @@
smp_mb();
synchronize_irq(tp->pdev->irq);
+ if (GET_ASIC_REV(tp->pci_chip_rev_id) == ASIC_REV_57780) {
+ val = tr32(TG3_PCIE_LNKCTL) & ~TG3_PCIE_LNKCTL_L1_PLL_PD_EN;
+ tw32(TG3_PCIE_LNKCTL, val | TG3_PCIE_LNKCTL_L1_PLL_PD_DIS);
+ }
+
/* do the reset */
val = GRC_MISC_CFG_CORECLK_RESET;
@@ -6726,6 +6740,15 @@
tw32(TG3_CORR_ERR_STAT, TG3_CORR_ERR_STAT_CLEAR);
}
+ if (tp->tg3_flags3 & TG3_FLG3_TOGGLE_10_100_L1PLLPD) {
+ val = tr32(TG3_PCIE_LNKCTL);
+ if (tp->tg3_flags3 & TG3_FLG3_CLKREQ_BUG)
+ val |= TG3_PCIE_LNKCTL_L1_PLL_PD_DIS;
+ else
+ val &= ~TG3_PCIE_LNKCTL_L1_PLL_PD_DIS;
+ tw32(TG3_PCIE_LNKCTL, val);
+ }
+
/* This works around an issue with Athlon chipsets on
* B3 tigon3 silicon. This bit has no effect on any
* other revision. But do not set this on PCI Express
@@ -12274,6 +12297,11 @@
GET_ASIC_REV(tp->pci_chip_rev_id) == ASIC_REV_57780)
tp->tg3_flags3 |= TG3_FLG3_USE_PHYLIB;
+ if ((tp->pci_chip_rev_id == CHIPREV_ID_57780_A1 &&
+ tr32(RCVLPC_STATS_ENABLE) & RCVLPC_STATSENAB_ASF_FIX) ||
+ tp->pci_chip_rev_id == CHIPREV_ID_57780_A0)
+ tp->tg3_flags3 |= TG3_FLG3_TOGGLE_10_100_L1PLLPD;
+
err = tg3_mdio_init(tp);
if (err)
return err;
diff --git a/drivers/net/tg3.h b/drivers/net/tg3.h
index c613cbb..bb8591e 100644
--- a/drivers/net/tg3.h
+++ b/drivers/net/tg3.h
@@ -866,6 +866,7 @@
#define RCVLPC_STATSCTRL_ENABLE 0x00000001
#define RCVLPC_STATSCTRL_FASTUPD 0x00000002
#define RCVLPC_STATS_ENABLE 0x00002018
+#define RCVLPC_STATSENAB_ASF_FIX 0x00000002
#define RCVLPC_STATSENAB_DACK_FIX 0x00040000
#define RCVLPC_STATSENAB_LNGBRST_RFIX 0x00400000
#define RCVLPC_STATS_INCMASK 0x0000201c
@@ -1704,7 +1705,12 @@
#define PCIE_PWR_MGMT_L1_THRESH_MSK 0x0000ff00
#define PCIE_PWR_MGMT_L1_THRESH_4MS 0x0000ff00
#define PCIE_PWR_MGMT_EXT_ASPM_TMR_EN 0x01000000
-/* 0x7d2c --> 0x7e70 unused */
+/* 0x7d2c --> 0x7d54 unused */
+
+#define TG3_PCIE_LNKCTL 0x00007d54
+#define TG3_PCIE_LNKCTL_L1_PLL_PD_EN 0x00000008
+#define TG3_PCIE_LNKCTL_L1_PLL_PD_DIS 0x00000080
+/* 0x7d58 --> 0x7e70 unused */
#define TG3_PCIE_EIDLE_DELAY 0x00007e70
#define TG3_PCIE_EIDLE_DELAY_MASK 0x0000001f
@@ -2650,6 +2656,7 @@
#define TG3_FLG3_PHY_ENABLE_APD 0x00001000
#define TG3_FLG3_5755_PLUS 0x00002000
#define TG3_FLG3_NO_NVRAM 0x00004000
+#define TG3_FLG3_TOGGLE_10_100_L1PLLPD 0x00008000
struct timer_list timer;
u16 timer_counter;