ASoC: adau1701: allow configuration of PLL mode pins
The ADAU1701 has 2 hardware pins to configure the PLL mode in accordance
to the MCLK-to-LRCLK ratio. These pins have to be stable before the chip
is released from reset, and a full reset cycle, including a new firmware
download is needed whenever they change.
This patch adds GPIO properties to the DT bindings of the Codec, and
implements makes the set_sysclk memorize the configured sysclk.
Because the run-time parameters are unknown at probe time, the first
firmware download is postponed to the first hw_params call, when the
driver can determine the mclk/lrclk divider. Subsequent downloads
are only issued when the divider configuration changes.
Signed-off-by: Daniel Mack <zonque@gmail.com>
Acked-by: Lars-Peter Clausen <lars@metafoo.de>
Signed-off-by: Mark Brown <broonie@linaro.org>
diff --git a/Documentation/devicetree/bindings/sound/adi,adau1701.txt b/Documentation/devicetree/bindings/sound/adi,adau1701.txt
index 3afeda7..a9fbed1 100644
--- a/Documentation/devicetree/bindings/sound/adi,adau1701.txt
+++ b/Documentation/devicetree/bindings/sound/adi,adau1701.txt
@@ -11,6 +11,11 @@
- reset-gpio: A GPIO spec to define which pin is connected to the
chip's !RESET pin. If specified, the driver will
assert a hardware reset at probe time.
+ - adi,pll-mode-gpios: An array of two GPIO specs to describe the GPIOs
+ the ADAU's PLL config pins are connected to.
+ The state of the pins are set according to the
+ configured clock divider on ASoC side before the
+ firmware is loaded.
Examples:
@@ -19,5 +24,6 @@
compatible = "adi,adau1701";
reg = <0x34>;
reset-gpio = <&gpio 23 0>;
+ adi,pll-mode-gpios = <&gpio 24 0 &gpio 25 0>;
};
};