Linux-2.6.12-rc2
Initial git repository build. I'm not bothering with the full history,
even though we have it. We can create a separate "historical" git
archive of that later if we want to, and in the meantime it's about
3.2GB when imported into git - space that would just make the early
git days unnecessarily complicated, when we don't have a lot of good
infrastructure for it.
Let it rip!
diff --git a/drivers/net/stnic.c b/drivers/net/stnic.c
new file mode 100644
index 0000000..b6dfdf8
--- /dev/null
+++ b/drivers/net/stnic.c
@@ -0,0 +1,320 @@
+/* stnic.c : A SH7750 specific part of driver for NS DP83902A ST-NIC.
+ *
+ * This file is subject to the terms and conditions of the GNU General Public
+ * License. See the file "COPYING" in the main directory of this archive
+ * for more details.
+ *
+ * Copyright (C) 1999 kaz Kojima
+ */
+
+#include <linux/config.h>
+#include <linux/module.h>
+#include <linux/kernel.h>
+#include <linux/errno.h>
+#include <linux/interrupt.h>
+#include <linux/ioport.h>
+#include <linux/netdevice.h>
+#include <linux/etherdevice.h>
+#include <linux/init.h>
+#include <linux/delay.h>
+
+#include <asm/system.h>
+#include <asm/io.h>
+#include <asm/se/se.h>
+#include <asm/machvec.h>
+#ifdef CONFIG_SH_STANDARD_BIOS
+#include <asm/sh_bios.h>
+#endif
+
+#include "8390.h"
+
+#define DRV_NAME "stnic"
+
+#define byte unsigned char
+#define half unsigned short
+#define word unsigned int
+#define vbyte volatile unsigned char
+#define vhalf volatile unsigned short
+#define vword volatile unsigned int
+
+#define STNIC_RUN 0x01 /* 1 == Run, 0 == reset. */
+
+#define START_PG 0 /* First page of TX buffer */
+#define STOP_PG 128 /* Last page +1 of RX ring */
+
+/* Alias */
+#define STNIC_CR E8390_CMD
+#define PG0_RSAR0 EN0_RSARLO
+#define PG0_RSAR1 EN0_RSARHI
+#define PG0_RBCR0 EN0_RCNTLO
+#define PG0_RBCR1 EN0_RCNTHI
+
+#define CR_RRD E8390_RREAD
+#define CR_RWR E8390_RWRITE
+#define CR_PG0 E8390_PAGE0
+#define CR_STA E8390_START
+#define CR_RDMA E8390_NODMA
+
+/* FIXME! YOU MUST SET YOUR OWN ETHER ADDRESS. */
+static byte stnic_eadr[6] =
+{0x00, 0xc0, 0x6e, 0x00, 0x00, 0x07};
+
+static struct net_device *stnic_dev;
+
+static int stnic_open (struct net_device *dev);
+static int stnic_close (struct net_device *dev);
+static void stnic_reset (struct net_device *dev);
+static void stnic_get_hdr (struct net_device *dev, struct e8390_pkt_hdr *hdr,
+ int ring_page);
+static void stnic_block_input (struct net_device *dev, int count,
+ struct sk_buff *skb , int ring_offset);
+static void stnic_block_output (struct net_device *dev, int count,
+ const unsigned char *buf, int start_page);
+
+static void stnic_init (struct net_device *dev);
+
+/* SH7750 specific read/write io. */
+static inline void
+STNIC_DELAY (void)
+{
+ vword trash;
+ trash = *(vword *) 0xa0000000;
+ trash = *(vword *) 0xa0000000;
+ trash = *(vword *) 0xa0000000;
+}
+
+static inline byte
+STNIC_READ (int reg)
+{
+ byte val;
+
+ val = (*(vhalf *) (PA_83902 + ((reg) << 1)) >> 8) & 0xff;
+ STNIC_DELAY ();
+ return val;
+}
+
+static inline void
+STNIC_WRITE (int reg, byte val)
+{
+ *(vhalf *) (PA_83902 + ((reg) << 1)) = ((half) (val) << 8);
+ STNIC_DELAY ();
+}
+
+static int __init stnic_probe(void)
+{
+ struct net_device *dev;
+ int i, err;
+
+ /* If we are not running on a SolutionEngine, give up now */
+ if (! MACH_SE)
+ return -ENODEV;
+
+ /* New style probing API */
+ dev = alloc_ei_netdev();
+ if (!dev)
+ return -ENOMEM;
+ SET_MODULE_OWNER(dev);
+
+#ifdef CONFIG_SH_STANDARD_BIOS
+ sh_bios_get_node_addr (stnic_eadr);
+#endif
+ for (i = 0; i < ETHER_ADDR_LEN; i++)
+ dev->dev_addr[i] = stnic_eadr[i];
+
+ /* Set the base address to point to the NIC, not the "real" base! */
+ dev->base_addr = 0x1000;
+ dev->irq = IRQ_STNIC;
+ dev->open = &stnic_open;
+ dev->stop = &stnic_close;
+#ifdef CONFIG_NET_POLL_CONTROLLER
+ dev->poll_controller = ei_poll;
+#endif
+
+ /* Snarf the interrupt now. There's no point in waiting since we cannot
+ share and the board will usually be enabled. */
+ err = request_irq (dev->irq, ei_interrupt, 0, DRV_NAME, dev);
+ if (err) {
+ printk (KERN_EMERG " unable to get IRQ %d.\n", dev->irq);
+ free_netdev(dev);
+ return err;
+ }
+
+ ei_status.name = dev->name;
+ ei_status.word16 = 1;
+#ifdef __LITTLE_ENDIAN__
+ ei_status.bigendian = 0;
+#else
+ ei_status.bigendian = 1;
+#endif
+ ei_status.tx_start_page = START_PG;
+ ei_status.rx_start_page = START_PG + TX_PAGES;
+ ei_status.stop_page = STOP_PG;
+
+ ei_status.reset_8390 = &stnic_reset;
+ ei_status.get_8390_hdr = &stnic_get_hdr;
+ ei_status.block_input = &stnic_block_input;
+ ei_status.block_output = &stnic_block_output;
+
+ stnic_init (dev);
+
+ err = register_netdev(dev);
+ if (err) {
+ free_irq(dev->irq, dev);
+ free_netdev(dev);
+ return err;
+ }
+ stnic_dev = dev;
+
+ printk (KERN_INFO "NS ST-NIC 83902A\n");
+
+ return 0;
+}
+
+static int
+stnic_open (struct net_device *dev)
+{
+#if 0
+ printk (KERN_DEBUG "stnic open\n");
+#endif
+ ei_open (dev);
+ return 0;
+}
+
+static int
+stnic_close (struct net_device *dev)
+{
+ ei_close (dev);
+ return 0;
+}
+
+static void
+stnic_reset (struct net_device *dev)
+{
+ *(vhalf *) PA_83902_RST = 0;
+ udelay (5);
+ if (ei_debug > 1)
+ printk (KERN_WARNING "8390 reset done (%ld).\n", jiffies);
+ *(vhalf *) PA_83902_RST = ~0;
+ udelay (5);
+}
+
+static void
+stnic_get_hdr (struct net_device *dev, struct e8390_pkt_hdr *hdr,
+ int ring_page)
+{
+ half buf[2];
+
+ STNIC_WRITE (PG0_RSAR0, 0);
+ STNIC_WRITE (PG0_RSAR1, ring_page);
+ STNIC_WRITE (PG0_RBCR0, 4);
+ STNIC_WRITE (PG0_RBCR1, 0);
+ STNIC_WRITE (STNIC_CR, CR_RRD | CR_PG0 | CR_STA);
+
+ buf[0] = *(vhalf *) PA_83902_IF;
+ STNIC_DELAY ();
+ buf[1] = *(vhalf *) PA_83902_IF;
+ STNIC_DELAY ();
+ hdr->next = buf[0] >> 8;
+ hdr->status = buf[0] & 0xff;
+#ifdef __LITTLE_ENDIAN__
+ hdr->count = buf[1];
+#else
+ hdr->count = ((buf[1] >> 8) & 0xff) | (buf[1] << 8);
+#endif
+
+ if (ei_debug > 1)
+ printk (KERN_DEBUG "ring %x status %02x next %02x count %04x.\n",
+ ring_page, hdr->status, hdr->next, hdr->count);
+
+ STNIC_WRITE (STNIC_CR, CR_RDMA | CR_PG0 | CR_STA);
+}
+
+/* Block input and output, similar to the Crynwr packet driver. If you are
+ porting to a new ethercard look at the packet driver source for hints.
+ The HP LAN doesn't use shared memory -- we put the packet
+ out through the "remote DMA" dataport. */
+
+static void
+stnic_block_input (struct net_device *dev, int length, struct sk_buff *skb,
+ int offset)
+{
+ char *buf = skb->data;
+ half val;
+
+ STNIC_WRITE (PG0_RSAR0, offset & 0xff);
+ STNIC_WRITE (PG0_RSAR1, offset >> 8);
+ STNIC_WRITE (PG0_RBCR0, length & 0xff);
+ STNIC_WRITE (PG0_RBCR1, length >> 8);
+ STNIC_WRITE (STNIC_CR, CR_RRD | CR_PG0 | CR_STA);
+
+ if (length & 1)
+ length++;
+
+ while (length > 0)
+ {
+ val = *(vhalf *) PA_83902_IF;
+#ifdef __LITTLE_ENDIAN__
+ *buf++ = val & 0xff;
+ *buf++ = val >> 8;
+#else
+ *buf++ = val >> 8;
+ *buf++ = val & 0xff;
+#endif
+ STNIC_DELAY ();
+ length -= sizeof (half);
+ }
+
+ STNIC_WRITE (STNIC_CR, CR_RDMA | CR_PG0 | CR_STA);
+}
+
+static void
+stnic_block_output (struct net_device *dev, int length,
+ const unsigned char *buf, int output_page)
+{
+ STNIC_WRITE (PG0_RBCR0, 1); /* Write non-zero value */
+ STNIC_WRITE (STNIC_CR, CR_RRD | CR_PG0 | CR_STA);
+ STNIC_DELAY ();
+
+ STNIC_WRITE (PG0_RBCR0, length & 0xff);
+ STNIC_WRITE (PG0_RBCR1, length >> 8);
+ STNIC_WRITE (PG0_RSAR0, 0);
+ STNIC_WRITE (PG0_RSAR1, output_page);
+ STNIC_WRITE (STNIC_CR, CR_RWR | CR_PG0 | CR_STA);
+
+ if (length & 1)
+ length++;
+
+ while (length > 0)
+ {
+#ifdef __LITTLE_ENDIAN__
+ *(vhalf *) PA_83902_IF = ((half) buf[1] << 8) | buf[0];
+#else
+ *(vhalf *) PA_83902_IF = ((half) buf[0] << 8) | buf[1];
+#endif
+ STNIC_DELAY ();
+ buf += sizeof (half);
+ length -= sizeof (half);
+ }
+
+ STNIC_WRITE (STNIC_CR, CR_RDMA | CR_PG0 | CR_STA);
+}
+
+/* This function resets the STNIC if something screws up. */
+static void
+stnic_init (struct net_device *dev)
+{
+ stnic_reset (dev);
+ NS8390_init (dev, 0);
+ return;
+}
+
+static void __exit stnic_cleanup(void)
+{
+ unregister_netdev(stnic_dev);
+ free_irq(stnic_dev->irq, stnic_dev);
+ free_netdev(stnic_dev);
+}
+
+module_init(stnic_probe);
+module_exit(stnic_cleanup);
+MODULE_LICENSE("GPL");