Linux-2.6.12-rc2
Initial git repository build. I'm not bothering with the full history,
even though we have it. We can create a separate "historical" git
archive of that later if we want to, and in the meantime it's about
3.2GB when imported into git - space that would just make the early
git days unnecessarily complicated, when we don't have a lot of good
infrastructure for it.
Let it rip!
diff --git a/drivers/net/8390.h b/drivers/net/8390.h
new file mode 100644
index 0000000..599b68d
--- /dev/null
+++ b/drivers/net/8390.h
@@ -0,0 +1,214 @@
+/* Generic NS8390 register definitions. */
+/* This file is part of Donald Becker's 8390 drivers, and is distributed
+ under the same license. Auto-loading of 8390.o only in v2.2 - Paul G.
+ Some of these names and comments originated from the Crynwr
+ packet drivers, which are distributed under the GPL. */
+
+#ifndef _8390_h
+#define _8390_h
+
+#include <linux/config.h>
+#include <linux/if_ether.h>
+#include <linux/ioport.h>
+#include <linux/skbuff.h>
+
+#define TX_PAGES 12 /* Two Tx slots */
+
+#define ETHER_ADDR_LEN 6
+
+/* The 8390 specific per-packet-header format. */
+struct e8390_pkt_hdr {
+ unsigned char status; /* status */
+ unsigned char next; /* pointer to next packet. */
+ unsigned short count; /* header + packet length in bytes */
+};
+
+#ifdef notdef
+extern int ei_debug;
+#else
+#define ei_debug 1
+#endif
+
+#ifdef CONFIG_NET_POLL_CONTROLLER
+extern void ei_poll(struct net_device *dev);
+#endif
+
+extern void NS8390_init(struct net_device *dev, int startp);
+extern int ei_open(struct net_device *dev);
+extern int ei_close(struct net_device *dev);
+extern irqreturn_t ei_interrupt(int irq, void *dev_id, struct pt_regs *regs);
+extern struct net_device *__alloc_ei_netdev(int size);
+static inline struct net_device *alloc_ei_netdev(void)
+{
+ return __alloc_ei_netdev(0);
+}
+
+/* You have one of these per-board */
+struct ei_device {
+ const char *name;
+ void (*reset_8390)(struct net_device *);
+ void (*get_8390_hdr)(struct net_device *, struct e8390_pkt_hdr *, int);
+ void (*block_output)(struct net_device *, int, const unsigned char *, int);
+ void (*block_input)(struct net_device *, int, struct sk_buff *, int);
+ unsigned long rmem_start;
+ unsigned long rmem_end;
+ void __iomem *mem;
+ unsigned char mcfilter[8];
+ unsigned open:1;
+ unsigned word16:1; /* We have the 16-bit (vs 8-bit) version of the card. */
+ unsigned bigendian:1; /* 16-bit big endian mode. Do NOT */
+ /* set this on random 8390 clones! */
+ unsigned txing:1; /* Transmit Active */
+ unsigned irqlock:1; /* 8390's intrs disabled when '1'. */
+ unsigned dmaing:1; /* Remote DMA Active */
+ unsigned char tx_start_page, rx_start_page, stop_page;
+ unsigned char current_page; /* Read pointer in buffer */
+ unsigned char interface_num; /* Net port (AUI, 10bT.) to use. */
+ unsigned char txqueue; /* Tx Packet buffer queue length. */
+ short tx1, tx2; /* Packet lengths for ping-pong tx. */
+ short lasttx; /* Alpha version consistency check. */
+ unsigned char reg0; /* Register '0' in a WD8013 */
+ unsigned char reg5; /* Register '5' in a WD8013 */
+ unsigned char saved_irq; /* Original dev->irq value. */
+ struct net_device_stats stat; /* The new statistics table. */
+ u32 *reg_offset; /* Register mapping table */
+ spinlock_t page_lock; /* Page register locks */
+ unsigned long priv; /* Private field to store bus IDs etc. */
+};
+
+/* The maximum number of 8390 interrupt service routines called per IRQ. */
+#define MAX_SERVICE 12
+
+/* The maximum time waited (in jiffies) before assuming a Tx failed. (20ms) */
+#define TX_TIMEOUT (20*HZ/100)
+
+#define ei_status (*(struct ei_device *)netdev_priv(dev))
+
+/* Some generic ethernet register configurations. */
+#define E8390_TX_IRQ_MASK 0xa /* For register EN0_ISR */
+#define E8390_RX_IRQ_MASK 0x5
+#define E8390_RXCONFIG 0x4 /* EN0_RXCR: broadcasts, no multicast,errors */
+#define E8390_RXOFF 0x20 /* EN0_RXCR: Accept no packets */
+#define E8390_TXCONFIG 0x00 /* EN0_TXCR: Normal transmit mode */
+#define E8390_TXOFF 0x02 /* EN0_TXCR: Transmitter off */
+
+/* Register accessed at EN_CMD, the 8390 base addr. */
+#define E8390_STOP 0x01 /* Stop and reset the chip */
+#define E8390_START 0x02 /* Start the chip, clear reset */
+#define E8390_TRANS 0x04 /* Transmit a frame */
+#define E8390_RREAD 0x08 /* Remote read */
+#define E8390_RWRITE 0x10 /* Remote write */
+#define E8390_NODMA 0x20 /* Remote DMA */
+#define E8390_PAGE0 0x00 /* Select page chip registers */
+#define E8390_PAGE1 0x40 /* using the two high-order bits */
+#define E8390_PAGE2 0x80 /* Page 3 is invalid. */
+
+/*
+ * Only generate indirect loads given a machine that needs them.
+ * - removed AMIGA_PCMCIA from this list, handled as ISA io now
+ */
+
+#if defined(CONFIG_MAC) || \
+ defined(CONFIG_ZORRO8390) || defined(CONFIG_ZORRO8390_MODULE) || \
+ defined(CONFIG_HYDRA) || defined(CONFIG_HYDRA_MODULE)
+#define EI_SHIFT(x) (ei_local->reg_offset[x])
+#undef inb
+#undef inb_p
+#undef outb
+#undef outb_p
+
+#define inb(port) in_8(port)
+#define outb(val,port) out_8(port,val)
+#define inb_p(port) in_8(port)
+#define outb_p(val,port) out_8(port,val)
+
+#elif defined(CONFIG_ARM_ETHERH) || defined(CONFIG_ARM_ETHERH_MODULE)
+#define EI_SHIFT(x) (ei_local->reg_offset[x])
+#undef inb
+#undef inb_p
+#undef outb
+#undef outb_p
+
+#define inb(_p) readb(_p)
+#define outb(_v,_p) writeb(_v,_p)
+#define inb_p(_p) inb(_p)
+#define outb_p(_v,_p) outb(_v,_p)
+
+#elif defined(CONFIG_NET_CBUS) || defined(CONFIG_NE_H8300) || defined(CONFIG_NE_H8300_MODULE)
+#define EI_SHIFT(x) (ei_local->reg_offset[x])
+#else
+#define EI_SHIFT(x) (x)
+#endif
+
+#define E8390_CMD EI_SHIFT(0x00) /* The command register (for all pages) */
+/* Page 0 register offsets. */
+#define EN0_CLDALO EI_SHIFT(0x01) /* Low byte of current local dma addr RD */
+#define EN0_STARTPG EI_SHIFT(0x01) /* Starting page of ring bfr WR */
+#define EN0_CLDAHI EI_SHIFT(0x02) /* High byte of current local dma addr RD */
+#define EN0_STOPPG EI_SHIFT(0x02) /* Ending page +1 of ring bfr WR */
+#define EN0_BOUNDARY EI_SHIFT(0x03) /* Boundary page of ring bfr RD WR */
+#define EN0_TSR EI_SHIFT(0x04) /* Transmit status reg RD */
+#define EN0_TPSR EI_SHIFT(0x04) /* Transmit starting page WR */
+#define EN0_NCR EI_SHIFT(0x05) /* Number of collision reg RD */
+#define EN0_TCNTLO EI_SHIFT(0x05) /* Low byte of tx byte count WR */
+#define EN0_FIFO EI_SHIFT(0x06) /* FIFO RD */
+#define EN0_TCNTHI EI_SHIFT(0x06) /* High byte of tx byte count WR */
+#define EN0_ISR EI_SHIFT(0x07) /* Interrupt status reg RD WR */
+#define EN0_CRDALO EI_SHIFT(0x08) /* low byte of current remote dma address RD */
+#define EN0_RSARLO EI_SHIFT(0x08) /* Remote start address reg 0 */
+#define EN0_CRDAHI EI_SHIFT(0x09) /* high byte, current remote dma address RD */
+#define EN0_RSARHI EI_SHIFT(0x09) /* Remote start address reg 1 */
+#define EN0_RCNTLO EI_SHIFT(0x0a) /* Remote byte count reg WR */
+#define EN0_RCNTHI EI_SHIFT(0x0b) /* Remote byte count reg WR */
+#define EN0_RSR EI_SHIFT(0x0c) /* rx status reg RD */
+#define EN0_RXCR EI_SHIFT(0x0c) /* RX configuration reg WR */
+#define EN0_TXCR EI_SHIFT(0x0d) /* TX configuration reg WR */
+#define EN0_COUNTER0 EI_SHIFT(0x0d) /* Rcv alignment error counter RD */
+#define EN0_DCFG EI_SHIFT(0x0e) /* Data configuration reg WR */
+#define EN0_COUNTER1 EI_SHIFT(0x0e) /* Rcv CRC error counter RD */
+#define EN0_IMR EI_SHIFT(0x0f) /* Interrupt mask reg WR */
+#define EN0_COUNTER2 EI_SHIFT(0x0f) /* Rcv missed frame error counter RD */
+
+/* Bits in EN0_ISR - Interrupt status register */
+#define ENISR_RX 0x01 /* Receiver, no error */
+#define ENISR_TX 0x02 /* Transmitter, no error */
+#define ENISR_RX_ERR 0x04 /* Receiver, with error */
+#define ENISR_TX_ERR 0x08 /* Transmitter, with error */
+#define ENISR_OVER 0x10 /* Receiver overwrote the ring */
+#define ENISR_COUNTERS 0x20 /* Counters need emptying */
+#define ENISR_RDC 0x40 /* remote dma complete */
+#define ENISR_RESET 0x80 /* Reset completed */
+#define ENISR_ALL 0x3f /* Interrupts we will enable */
+
+/* Bits in EN0_DCFG - Data config register */
+#define ENDCFG_WTS 0x01 /* word transfer mode selection */
+#define ENDCFG_BOS 0x02 /* byte order selection */
+
+/* Page 1 register offsets. */
+#define EN1_PHYS EI_SHIFT(0x01) /* This board's physical enet addr RD WR */
+#define EN1_PHYS_SHIFT(i) EI_SHIFT(i+1) /* Get and set mac address */
+#define EN1_CURPAG EI_SHIFT(0x07) /* Current memory page RD WR */
+#define EN1_MULT EI_SHIFT(0x08) /* Multicast filter mask array (8 bytes) RD WR */
+#define EN1_MULT_SHIFT(i) EI_SHIFT(8+i) /* Get and set multicast filter */
+
+/* Bits in received packet status byte and EN0_RSR*/
+#define ENRSR_RXOK 0x01 /* Received a good packet */
+#define ENRSR_CRC 0x02 /* CRC error */
+#define ENRSR_FAE 0x04 /* frame alignment error */
+#define ENRSR_FO 0x08 /* FIFO overrun */
+#define ENRSR_MPA 0x10 /* missed pkt */
+#define ENRSR_PHY 0x20 /* physical/multicast address */
+#define ENRSR_DIS 0x40 /* receiver disable. set in monitor mode */
+#define ENRSR_DEF 0x80 /* deferring */
+
+/* Transmitted packet status, EN0_TSR. */
+#define ENTSR_PTX 0x01 /* Packet transmitted without error */
+#define ENTSR_ND 0x02 /* The transmit wasn't deferred. */
+#define ENTSR_COL 0x04 /* The transmit collided at least once. */
+#define ENTSR_ABT 0x08 /* The transmit collided 16 times, and was deferred. */
+#define ENTSR_CRS 0x10 /* The carrier sense was lost. */
+#define ENTSR_FU 0x20 /* A "FIFO underrun" occurred during transmit. */
+#define ENTSR_CDH 0x40 /* The collision detect "heartbeat" signal was lost. */
+#define ENTSR_OWC 0x80 /* There was an out-of-window collision. */
+
+#endif /* _8390_h */