mac80211: support RX_FLAG_MACTIME_END
Allow drivers to indicate their mactime is at RX completion and adjust
for this in mac80211. Also rename the existing RX_FLAG_MACTIME_MPDU to
RX_FLAG_MACTIME_START to clarify its intent. Based on similar code by
Johannes Berg.
Signed-off-by: Thomas Pedersen <thomas@cozybit.com>
[fix docs, atheros drivers]
Signed-off-by: Johannes Berg <johannes.berg@intel.com>
diff --git a/net/mac80211/ibss.c b/net/mac80211/ibss.c
index c7386b2..cc11558 100644
--- a/net/mac80211/ibss.c
+++ b/net/mac80211/ibss.c
@@ -543,30 +543,11 @@
if (ether_addr_equal(cbss->bssid, sdata->u.ibss.bssid))
goto put_bss;
- if (rx_status->flag & RX_FLAG_MACTIME_MPDU) {
- /*
- * For correct IBSS merging we need mactime; since mactime is
- * defined as the time the first data symbol of the frame hits
- * the PHY, and the timestamp of the beacon is defined as "the
- * time that the data symbol containing the first bit of the
- * timestamp is transmitted to the PHY plus the transmitting
- * STA's delays through its local PHY from the MAC-PHY
- * interface to its interface with the WM" (802.11 11.1.2)
- * - equals the time this bit arrives at the receiver - we have
- * to take into account the offset between the two.
- *
- * E.g. at 1 MBit that means mactime is 192 usec earlier
- * (=24 bytes * 8 usecs/byte) than the beacon timestamp.
- */
- int rate;
-
- if (rx_status->flag & RX_FLAG_HT)
- rate = 65; /* TODO: HT rates */
- else
- rate = local->hw.wiphy->bands[band]->
- bitrates[rx_status->rate_idx].bitrate;
-
- rx_timestamp = rx_status->mactime + (24 * 8 * 10 / rate);
+ if (ieee80211_have_rx_timestamp(rx_status)) {
+ /* time when timestamp field was received */
+ rx_timestamp =
+ ieee80211_calculate_rx_timestamp(local, rx_status,
+ len + FCS_LEN, 24);
} else {
/*
* second best option: get current TSF