spi: sh-hspi: Remove duplicate code to set default transfer speed
In the implementation of __spi_validate(), spi core will use spi device's max
speed as default transfer speed if it is not set for this transfer.
So we can remove the same logic in hspi_hw_setup().
Signed-off-by: Axel Lin <axel.lin@ingics.com>
Acked-by: Geert Uytterhoeven <geert@linux-m68k.org>
Signed-off-by: Mark Brown <broonie@linaro.org>
diff --git a/drivers/spi/spi-sh-hspi.c b/drivers/spi/spi-sh-hspi.c
index dad800b..180eecf 100644
--- a/drivers/spi/spi-sh-hspi.c
+++ b/drivers/spi/spi-sh-hspi.c
@@ -111,14 +111,9 @@
{
struct spi_device *spi = msg->spi;
struct device *dev = hspi->dev;
- u32 target_rate;
u32 spcr, idiv_clk;
u32 rate, best_rate, min, tmp;
- target_rate = t ? t->speed_hz : 0;
- if (!target_rate)
- target_rate = spi->max_speed_hz;
-
/*
* find best IDIV/CLKCx settings
*/
@@ -138,7 +133,7 @@
rate /= (((idiv_clk & 0x1F) + 1) * 2);
/* save best settings */
- tmp = abs(target_rate - rate);
+ tmp = abs(t->speed_hz - rate);
if (tmp < min) {
min = tmp;
spcr = idiv_clk;
@@ -151,7 +146,7 @@
if (spi->mode & SPI_CPOL)
spcr |= 1 << 6;
- dev_dbg(dev, "speed %d/%d\n", target_rate, best_rate);
+ dev_dbg(dev, "speed %d/%d\n", t->speed_hz, best_rate);
hspi_write(hspi, SPCR, spcr);
hspi_write(hspi, SPSR, 0x0);