cfg80211/mac80211: DFS setup chandef for cac event
To report channel width correctly we have
to send correct channel parameters from
mac80211 when calling cfg80211_cac_event().
This is required in case of using channel width
higher than 20MHz and we have to set correct
dfs channel state after CAC (NL80211_DFS_AVAILABLE).
Signed-off-by: Janusz Dziedzic <janusz.dziedzic@tieto.com>
Reviewed-by: Luis R. Rodriguez <mcgrof@do-not-panic.com>
Signed-off-by: Johannes Berg <johannes.berg@intel.com>
diff --git a/net/mac80211/cfg.c b/net/mac80211/cfg.c
index 95667b0..5232b01 100644
--- a/net/mac80211/cfg.c
+++ b/net/mac80211/cfg.c
@@ -1050,6 +1050,7 @@
struct ieee80211_local *local = sdata->local;
struct beacon_data *old_beacon;
struct probe_resp *old_probe_resp;
+ struct cfg80211_chan_def chandef;
old_beacon = rtnl_dereference(sdata->u.ap.beacon);
if (!old_beacon)
@@ -1091,8 +1092,10 @@
ieee80211_bss_info_change_notify(sdata, BSS_CHANGED_BEACON_ENABLED);
if (sdata->wdev.cac_started) {
+ chandef = sdata->vif.bss_conf.chandef;
cancel_delayed_work_sync(&sdata->dfs_cac_timer_work);
- cfg80211_cac_event(sdata->dev, NL80211_RADAR_CAC_ABORTED,
+ cfg80211_cac_event(sdata->dev, &chandef,
+ NL80211_RADAR_CAC_ABORTED,
GFP_KERNEL);
}