diff --git a/Documentation/scsi/ncr53c8xx.txt b/Documentation/scsi/ncr53c8xx.txt
index fb9281a..e80a02c 100644
--- a/Documentation/scsi/ncr53c8xx.txt
+++ b/Documentation/scsi/ncr53c8xx.txt
@@ -96,10 +96,10 @@
 It is now available as a bundle of 2 drivers:
 
 - ncr53c8xx generic driver that supports all the SYM53C8XX family including 
-  the ealiest 810 rev. 1, the latest 896 (2 channel LVD SCSI controller) and
+  the earliest 810 rev. 1, the latest 896 (2 channel LVD SCSI controller) and
   the new 895A (1 channel LVD SCSI controller).
 - sym53c8xx enhanced driver (a.k.a. 896 drivers) that drops support of oldest 
-  chips in order to gain advantage of new features, as LOAD/STORE intructions 
+  chips in order to gain advantage of new features, as LOAD/STORE instructions 
   available since the 810A and hardware phase mismatch available with the 
   896 and the 895A.
 
@@ -207,7 +207,7 @@
 SCRIPTS (avoids the phase mismatch interrupt that stops the SCSI processor 
 until the C code has saved the context of the transfer).
 Implementing this without using LOAD/STORE instructions would be painfull 
-and I did'nt even want to try it.
+and I didn't even want to try it.
 
 The 896 chip supports 64 bit PCI transactions and addressing, while the 
 895A supports 32 bit PCI transactions and 64 bit addressing.
diff --git a/Documentation/scsi/scsi_eh.txt b/Documentation/scsi/scsi_eh.txt
index ce767b9..8d6253f 100644
--- a/Documentation/scsi/scsi_eh.txt
+++ b/Documentation/scsi/scsi_eh.txt
@@ -160,7 +160,7 @@
  - Fine-grained EH callbacks
 	LLDD can implement fine-grained EH callbacks and let SCSI
 	midlayer drive error handling and call appropriate callbacks.
-	This will be dicussed further in [2-1].
+	This will be discussed further in [2-1].
 
  - eh_strategy_handler() callback
 	This is one big callback which should perform whole error
diff --git a/Documentation/scsi/tmscsim.txt b/Documentation/scsi/tmscsim.txt
index 2bf3cfa..8b2168a 100644
--- a/Documentation/scsi/tmscsim.txt
+++ b/Documentation/scsi/tmscsim.txt
@@ -381,7 +381,7 @@
   replaced by the dev index of your scanner). You may try to reset your SCSI
   bus afterwards (echo "RESET" >/proc/scsi/tmscsim/?).
   The problem seems to be solved as of 2.0d18, thanks to Andreas Rick.
-* If there is a valid partition table, the driver will use it for determing
+* If there is a valid partition table, the driver will use it for determining
   the mapping. If there's none, a reasonable mapping (Symbios-like) will be
   assumed. Other operating systems may not like this mapping, though
   it's consistent with the BIOS' behaviour. Old DC390 drivers ignored the