Add documentation for extended crashkernel syntax
This adds the documentation for the extended crashkernel syntax into
Documentation/kdump/kdump.txt.
Signed-off-by: Bernhard Walle <bwalle@suse.de>
Cc: Andi Kleen <ak@suse.de>
Cc: "Luck, Tony" <tony.luck@intel.com>
Cc: Paul Mackerras <paulus@samba.org>
Cc: Benjamin Herrenschmidt <benh@kernel.crashing.org>
Cc: Paul Mundt <lethal@linux-sh.org>
Cc: Vivek Goyal <vgoyal@in.ibm.com>
Cc: "Eric W. Biederman" <ebiederm@xmission.com>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
diff --git a/Documentation/kdump/kdump.txt b/Documentation/kdump/kdump.txt
index 1b37b28..d0ac72c 100644
--- a/Documentation/kdump/kdump.txt
+++ b/Documentation/kdump/kdump.txt
@@ -231,6 +231,32 @@
any space below the alignment point will be wasted.
+Extended crashkernel syntax
+===========================
+
+While the "crashkernel=size[@offset]" syntax is sufficient for most
+configurations, sometimes it's handy to have the reserved memory dependent
+on the value of System RAM -- that's mostly for distributors that pre-setup
+the kernel command line to avoid a unbootable system after some memory has
+been removed from the machine.
+
+The syntax is:
+
+ crashkernel=<range1>:<size1>[,<range2>:<size2>,...][@offset]
+ range=start-[end]
+
+For example:
+
+ crashkernel=512M-2G:64M,2G-:128M
+
+This would mean:
+
+ 1) if the RAM is smaller than 512M, then don't reserve anything
+ (this is the "rescue" case)
+ 2) if the RAM size is between 512M and 2G, then reserve 64M
+ 3) if the RAM size is larger than 2G, then reserve 128M
+
+
Boot into System Kernel
=======================
diff --git a/Documentation/kernel-parameters.txt b/Documentation/kernel-parameters.txt
index 189df0b..0a3fed4 100644
--- a/Documentation/kernel-parameters.txt
+++ b/Documentation/kernel-parameters.txt
@@ -497,6 +497,13 @@
[KNL] Reserve a chunk of physical memory to
hold a kernel to switch to with kexec on panic.
+ crashkernel=range1:size1[,range2:size2,...][@offset]
+ [KNL] Same as above, but depends on the memory
+ in the running system. The syntax of range is
+ start-[end] where start and end are both
+ a memory unit (amount[KMG]). See also
+ Documentation/kdump/kdump.txt for a example.
+
cs4232= [HW,OSS]
Format: <io>,<irq>,<dma>,<dma2>,<mpuio>,<mpuirq>