i2c: support 10 bit and slave addresses in sysfs 'new_device'
We now have seperate address spaces for 10 bit and we-are-slave clients.
Update the sysfs device instantiation method to support these types by
accepting the address offsets that are assigned to the extra address
spaces. Update the documentation, too.
Signed-off-by: Wolfram Sang <wsa+renesas@sang-engineering.com>
Signed-off-by: Wolfram Sang <wsa@the-dreams.de>
diff --git a/Documentation/i2c/slave-interface b/Documentation/i2c/slave-interface
index 2dee4e2..61ed05c 100644
--- a/Documentation/i2c/slave-interface
+++ b/Documentation/i2c/slave-interface
@@ -31,10 +31,13 @@
===========
I2C slave backends behave like standard I2C clients. So, you can instantiate
-them as described in the document 'instantiating-devices'. A quick example for
-instantiating the slave-eeprom driver from userspace at address 0x64 on bus 1:
+them as described in the document 'instantiating-devices'. The only difference
+is that i2c slave backends have their own address space. So, you have to add
+0x1000 to the address you would originally request. An example for
+instantiating the slave-eeprom driver from userspace at the 7 bit address 0x64
+on bus 1:
- # echo slave-24c02 0x64 > /sys/bus/i2c/devices/i2c-1/new_device
+ # echo slave-24c02 0x1064 > /sys/bus/i2c/devices/i2c-1/new_device
Each backend should come with separate documentation to describe its specific
behaviour and setup.
diff --git a/Documentation/i2c/ten-bit-addresses b/Documentation/i2c/ten-bit-addresses
index cdfe139..7b2d11e 100644
--- a/Documentation/i2c/ten-bit-addresses
+++ b/Documentation/i2c/ten-bit-addresses
@@ -2,6 +2,10 @@
addresses, and an extended set of 10 bit addresses. The sets of addresses
do not intersect: the 7 bit address 0x10 is not the same as the 10 bit
address 0x10 (though a single device could respond to both of them).
+To avoid ambiguity, the user sees 10 bit addresses mapped to a different
+address space, namely 0xa000-0xa3ff. The leading 0xa (= 10) represents the
+10 bit mode. This is used for creating device names in sysfs. It is also
+needed when instantiating 10 bit devices via the new_device file in sysfs.
I2C messages to and from 10-bit address devices have a different format.
See the I2C specification for the details.