driver/net: enic: record q_number and rss_hash for skb

The following patch sets the skb->rxhash and skb->q_number.
This is used by RPS and RFS. Kernel can make use of hw provided hash
instead of calculating the hash.

Signed-off-by: Govindarajulu Varadarajan <govindarajulu90@gmail.com>
Signed-off-by: Nishank Trivedi <nistrive@cisco.com>
Signed-off-by: Christian Benvenuti <benve@cisco.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/ethernet/cisco/enic/enic_main.c b/drivers/net/ethernet/cisco/enic/enic_main.c
index 1ab3f18..93898ba 100644
--- a/drivers/net/ethernet/cisco/enic/enic_main.c
+++ b/drivers/net/ethernet/cisco/enic/enic_main.c
@@ -1034,6 +1034,14 @@
 
 		skb_put(skb, bytes_written);
 		skb->protocol = eth_type_trans(skb, netdev);
+		skb_record_rx_queue(skb, q_number);
+		if (netdev->features & NETIF_F_RXHASH) {
+			skb->rxhash = rss_hash;
+			if (rss_type & (NIC_CFG_RSS_HASH_TYPE_TCP_IPV6_EX |
+					NIC_CFG_RSS_HASH_TYPE_TCP_IPV6 |
+					NIC_CFG_RSS_HASH_TYPE_TCP_IPV4))
+				skb->l4_rxhash = true;
+		}
 
 		if ((netdev->features & NETIF_F_RXCSUM) && !csum_not_calc) {
 			skb->csum = htons(checksum);
@@ -2209,6 +2217,7 @@
 	}
 
 	netif_set_real_num_tx_queues(netdev, enic->wq_count);
+	netif_set_real_num_rx_queues(netdev, enic->rq_count);
 
 	/* Setup notification timer, HW reset task, and wq locks
 	 */
@@ -2258,6 +2267,8 @@
 	if (ENIC_SETTING(enic, TSO))
 		netdev->hw_features |= NETIF_F_TSO |
 			NETIF_F_TSO6 | NETIF_F_TSO_ECN;
+	if (ENIC_SETTING(enic, RSS))
+		netdev->hw_features |= NETIF_F_RXHASH;
 	if (ENIC_SETTING(enic, RXCSUM))
 		netdev->hw_features |= NETIF_F_RXCSUM;