[libata] use dev_printk() throughout drivers
A few drivers were not following the standard meme of printing out
their driver name and version at module load time; this is fixed
as well.
diff --git a/drivers/scsi/sata_sil24.c b/drivers/scsi/sata_sil24.c
index 4afe2b1..c665480 100644
--- a/drivers/scsi/sata_sil24.c
+++ b/drivers/scsi/sata_sil24.c
@@ -35,6 +35,7 @@
#include <linux/delay.h>
#include <linux/interrupt.h>
#include <linux/dma-mapping.h>
+#include <linux/device.h>
#include <scsi/scsi_host.h>
#include "scsi.h"
#include <linux/libata.h>
@@ -690,7 +691,7 @@
int i, rc;
if (!printed_version++)
- printk(KERN_DEBUG DRV_NAME " version " DRV_VERSION "\n");
+ dev_printk(KERN_DEBUG, &pdev->dev, "version " DRV_VERSION "\n");
rc = pci_enable_device(pdev);
if (rc)
@@ -750,14 +751,14 @@
*/
rc = pci_set_dma_mask(pdev, DMA_32BIT_MASK);
if (rc) {
- printk(KERN_ERR DRV_NAME "(%s): 32-bit DMA enable failed\n",
- pci_name(pdev));
+ dev_printk(KERN_ERR, &pdev->dev,
+ "32-bit DMA enable failed\n");
goto out_free;
}
rc = pci_set_consistent_dma_mask(pdev, DMA_32BIT_MASK);
if (rc) {
- printk(KERN_ERR DRV_NAME "(%s): 32-bit consistent DMA enable failed\n",
- pci_name(pdev));
+ dev_printk(KERN_ERR, &pdev->dev,
+ "32-bit consistent DMA enable failed\n");
goto out_free;
}
@@ -793,9 +794,8 @@
break;
}
if (tmp & PORT_CS_PORT_RST)
- printk(KERN_ERR DRV_NAME
- "(%s): failed to clear port RST\n",
- pci_name(pdev));
+ dev_printk(KERN_ERR, &pdev->dev,
+ "failed to clear port RST\n");
}
/* Zero error counters. */
@@ -824,9 +824,8 @@
/* Reset itself */
if (__sil24_reset_controller(port))
- printk(KERN_ERR DRV_NAME
- "(%s): failed to reset controller\n",
- pci_name(pdev));
+ dev_printk(KERN_ERR, &pdev->dev,
+ "failed to reset controller\n");
}
/* Turn on interrupts */