[PATCH] PCI: do VIA IRQ fixup always, not just in PIC mode
At least some VIA chipsets require the fixup even in IO-APIC mode.
This was found and debugged with the patient assistance of Stian
Jordet <liste@jordet.nu> on an Asus CUV266-DLS motherboard.
Signed-off-by: Bjorn Helgaas <bjorn.helgaas@hp.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
diff --git a/drivers/pci/quirks.c b/drivers/pci/quirks.c
index 637e949..2194669 100644
--- a/drivers/pci/quirks.c
+++ b/drivers/pci/quirks.c
@@ -460,17 +460,6 @@
/*
- * Via 686A/B: The PCI_INTERRUPT_LINE register for the on-chip
- * devices, USB0/1, AC97, MC97, and ACPI, has an unusual feature:
- * when written, it makes an internal connection to the PIC.
- * For these devices, this register is defined to be 4 bits wide.
- * Normally this is fine. However for IO-APIC motherboards, or
- * non-x86 architectures (yes Via exists on PPC among other places),
- * we must mask the PCI_INTERRUPT_LINE value versus 0xf to get
- * interrupts delivered properly.
- */
-
-/*
* FIXME: it is questionable that quirk_via_acpi
* is needed. It shows up as an ISA bridge, and does not
* support the PCI_INTERRUPT_LINE register at all. Therefore
@@ -492,28 +481,30 @@
DECLARE_PCI_FIXUP_HEADER(PCI_VENDOR_ID_VIA, PCI_DEVICE_ID_VIA_82C586_3, quirk_via_acpi );
DECLARE_PCI_FIXUP_HEADER(PCI_VENDOR_ID_VIA, PCI_DEVICE_ID_VIA_82C686_4, quirk_via_acpi );
-static void quirk_via_irqpic(struct pci_dev *dev)
+/*
+ * Via 686A/B: The PCI_INTERRUPT_LINE register for the on-chip
+ * devices, USB0/1, AC97, MC97, and ACPI, has an unusual feature:
+ * when written, it makes an internal connection to the PIC.
+ * For these devices, this register is defined to be 4 bits wide.
+ * Normally this is fine. However for IO-APIC motherboards, or
+ * non-x86 architectures (yes Via exists on PPC among other places),
+ * we must mask the PCI_INTERRUPT_LINE value versus 0xf to get
+ * interrupts delivered properly.
+ */
+static void quirk_via_irq(struct pci_dev *dev)
{
u8 irq, new_irq;
-#ifdef CONFIG_X86_IO_APIC
- if (nr_ioapics && !skip_ioapic_setup)
- return;
-#endif
-#ifdef CONFIG_ACPI
- if (acpi_irq_model != ACPI_IRQ_MODEL_PIC)
- return;
-#endif
new_irq = dev->irq & 0xf;
pci_read_config_byte(dev, PCI_INTERRUPT_LINE, &irq);
if (new_irq != irq) {
- printk(KERN_INFO "PCI: Via PIC IRQ fixup for %s, from %d to %d\n",
+ printk(KERN_INFO "PCI: Via IRQ fixup for %s, from %d to %d\n",
pci_name(dev), irq, new_irq);
udelay(15); /* unknown if delay really needed */
pci_write_config_byte(dev, PCI_INTERRUPT_LINE, new_irq);
}
}
-DECLARE_PCI_FIXUP_ENABLE(PCI_VENDOR_ID_VIA, PCI_ANY_ID, quirk_via_irqpic);
+DECLARE_PCI_FIXUP_ENABLE(PCI_VENDOR_ID_VIA, PCI_ANY_ID, quirk_via_irq);
/*
* PIIX3 USB: We have to disable USB interrupts that are