mac80211: set auth flags after other station info
For TDLS, the AUTHORIZED flag arrives with all other important station
info (supported rates, HT/VHT caps, ...). Make sure to set the station
state in the low-level driver after transferring this information to
the mac80211 STA entry.
This aligns the STA information during sta_state callbacks with the
non-TDLS case.
Signed-off-by: Arik Nemtsov <arikx.nemtsov@intel.com>
Reviewed-by: Emmanuel Grumbach <emmanuel.grumbach@intel.com>
Signed-off-by: Johannes Berg <johannes.berg@intel.com>
diff --git a/net/mac80211/cfg.c b/net/mac80211/cfg.c
index a0d7a03..73c9e10 100644
--- a/net/mac80211/cfg.c
+++ b/net/mac80211/cfg.c
@@ -997,9 +997,12 @@
}
}
- ret = sta_apply_auth_flags(local, sta, mask, set);
- if (ret)
- return ret;
+ /* auth flags will be set later for TDLS stations */
+ if (!test_sta_flag(sta, WLAN_STA_TDLS_PEER)) {
+ ret = sta_apply_auth_flags(local, sta, mask, set);
+ if (ret)
+ return ret;
+ }
if (mask & BIT(NL80211_STA_FLAG_SHORT_PREAMBLE)) {
if (set & BIT(NL80211_STA_FLAG_SHORT_PREAMBLE))
@@ -1136,6 +1139,13 @@
#endif
}
+ /* set the STA state after all sta info from usermode has been set */
+ if (test_sta_flag(sta, WLAN_STA_TDLS_PEER)) {
+ ret = sta_apply_auth_flags(local, sta, mask, set);
+ if (ret)
+ return ret;
+ }
+
return 0;
}