Merge remote-tracking branches 'regulator/topic/gpio', 'regulator/topic/lp873x', 'regulator/topic/max77620', 'regulator/topic/pwm' and 'regulator/topic/tps6507x' into regulator-next
diff --git a/Documentation/devicetree/bindings/mfd/lp873x.txt b/Documentation/devicetree/bindings/mfd/lp873x.txt
index 52766c2..ae9cf39 100644
--- a/Documentation/devicetree/bindings/mfd/lp873x.txt
+++ b/Documentation/devicetree/bindings/mfd/lp873x.txt
@@ -7,6 +7,9 @@
- #gpio-cells: Should be two. The first cell is the pin number and
the second cell is used to specify flags.
See ../gpio/gpio.txt for more information.
+ - xxx-in-supply: Phandle to parent supply node of each regulator
+ populated under regulators node. xxx can be
+ buck0, buck1, ldo0 or ldo1.
- regulators: List of child nodes that specify the regulator
initialization data.
Example:
@@ -17,6 +20,11 @@
gpio-controller;
#gpio-cells = <2>;
+ buck0-in-supply = <&vsys_3v3>;
+ buck1-in-supply = <&vsys_3v3>;
+ ldo0-in-supply = <&vsys_3v3>;
+ ldo1-in-supply = <&vsys_3v3>;
+
regulators {
lp8733_buck0: buck0 {
regulator-name = "lp8733-buck0";
diff --git a/Documentation/devicetree/bindings/mfd/max77620.txt b/Documentation/devicetree/bindings/mfd/max77620.txt
index 2ad44f7..9c16d51 100644
--- a/Documentation/devicetree/bindings/mfd/max77620.txt
+++ b/Documentation/devicetree/bindings/mfd/max77620.txt
@@ -106,6 +106,18 @@
MAX77620 supports 40, 80, 160, 320, 640, 1280, 2560 and 5120 microseconds.
MAX20024 supports 20, 40, 80, 160, 320, 640, 1280 and 2540 microseconds.
+-maxim,power-ok-control: configure map power ok bit
+ 1: Enables POK(Power OK) to control nRST_IO and GPIO1
+ POK function.
+ 0: Disables POK control.
+ if property missing, do not configure MPOK bit.
+ If POK mapping is enabled for GPIO1/nRST_IO then,
+ GPIO1/nRST_IO pins are HIGH only if all rails
+ that have POK control enabled are HIGH.
+ If any of the rails goes down(which are enabled for POK
+ control) then, GPIO1/nRST_IO goes LOW.
+ this property is valid for max20024 only.
+
For DT binding details of different sub modules like GPIO, pincontrol,
regulator, power, please refer respective device-tree binding document
under their respective sub-system directories.
diff --git a/Documentation/devicetree/bindings/regulator/pwm-regulator.txt b/Documentation/devicetree/bindings/regulator/pwm-regulator.txt
index 3aeba9f..bf85aa9 100644
--- a/Documentation/devicetree/bindings/regulator/pwm-regulator.txt
+++ b/Documentation/devicetree/bindings/regulator/pwm-regulator.txt
@@ -59,7 +59,7 @@
Continuous Voltage With Enable GPIO Example:
pwm_regulator {
- compatible = "pwm-regulator;
+ compatible = "pwm-regulator";
pwms = <&pwm1 0 8448 0>;
enable-gpios = <&gpio0 23 GPIO_ACTIVE_HIGH>;
regulator-min-microvolt = <1016000>;
@@ -76,7 +76,7 @@
Voltage Table Example:
pwm_regulator {
- compatible = "pwm-regulator;
+ compatible = "pwm-regulator";
pwms = <&pwm1 0 8448 0>;
regulator-min-microvolt = <1016000>;
regulator-max-microvolt = <1114000>;
diff --git a/drivers/regulator/gpio-regulator.c b/drivers/regulator/gpio-regulator.c
index 83e89e5..0fce06a 100644
--- a/drivers/regulator/gpio-regulator.c
+++ b/drivers/regulator/gpio-regulator.c
@@ -162,8 +162,8 @@ of_get_gpio_regulator_config(struct device *dev, struct device_node *np,
of_property_read_u32(np, "startup-delay-us", &config->startup_delay);
config->enable_gpio = of_get_named_gpio(np, "enable-gpio", 0);
- if (config->enable_gpio == -EPROBE_DEFER)
- return ERR_PTR(-EPROBE_DEFER);
+ if (config->enable_gpio < 0 && config->enable_gpio != -ENOENT)
+ return ERR_PTR(config->enable_gpio);
/* Fetch GPIOs. - optional property*/
ret = of_gpio_count(np);
@@ -190,8 +190,11 @@ of_get_gpio_regulator_config(struct device *dev, struct device_node *np,
for (i = 0; i < config->nr_gpios; i++) {
gpio = of_get_named_gpio(np, "gpios", i);
- if (gpio < 0)
+ if (gpio < 0) {
+ if (gpio != -ENOENT)
+ return ERR_PTR(gpio);
break;
+ }
config->gpios[i].gpio = gpio;
if (proplen > 0) {
of_property_read_u32_index(np, "gpios-states",
diff --git a/drivers/regulator/lp873x-regulator.c b/drivers/regulator/lp873x-regulator.c
index e504b91..70e3df6 100644
--- a/drivers/regulator/lp873x-regulator.c
+++ b/drivers/regulator/lp873x-regulator.c
@@ -24,6 +24,7 @@
[_id] = { \
.desc = { \
.name = _name, \
+ .supply_name = _of "-in", \
.id = _id, \
.of_match = of_match_ptr(_of), \
.regulators_node = of_match_ptr("regulators"),\
diff --git a/drivers/regulator/max77620-regulator.c b/drivers/regulator/max77620-regulator.c
index a1b49a6..d088a7c 100644
--- a/drivers/regulator/max77620-regulator.c
+++ b/drivers/regulator/max77620-regulator.c
@@ -73,7 +73,6 @@ struct max77620_regulator_info {
};
struct max77620_regulator_pdata {
- struct regulator_init_data *reg_idata;
int active_fps_src;
int active_fps_pd_slot;
int active_fps_pu_slot;
@@ -81,6 +80,7 @@ struct max77620_regulator_pdata {
int suspend_fps_pd_slot;
int suspend_fps_pu_slot;
int current_mode;
+ int power_ok;
int ramp_rate_setting;
};
@@ -351,11 +351,48 @@ static int max77620_set_slew_rate(struct max77620_regulator *pmic, int id,
return 0;
}
+static int max77620_config_power_ok(struct max77620_regulator *pmic, int id)
+{
+ struct max77620_regulator_pdata *rpdata = &pmic->reg_pdata[id];
+ struct max77620_regulator_info *rinfo = pmic->rinfo[id];
+ struct max77620_chip *chip = dev_get_drvdata(pmic->dev->parent);
+ u8 val, mask;
+ int ret;
+
+ switch (chip->chip_id) {
+ case MAX20024:
+ if (rpdata->power_ok >= 0) {
+ if (rinfo->type == MAX77620_REGULATOR_TYPE_SD)
+ mask = MAX20024_SD_CFG1_MPOK_MASK;
+ else
+ mask = MAX20024_LDO_CFG2_MPOK_MASK;
+
+ val = rpdata->power_ok ? mask : 0;
+
+ ret = regmap_update_bits(pmic->rmap, rinfo->cfg_addr,
+ mask, val);
+ if (ret < 0) {
+ dev_err(pmic->dev, "Reg 0x%02x update failed %d\n",
+ rinfo->cfg_addr, ret);
+ return ret;
+ }
+ }
+ break;
+
+ default:
+ break;
+ }
+
+ return 0;
+}
+
static int max77620_init_pmic(struct max77620_regulator *pmic, int id)
{
struct max77620_regulator_pdata *rpdata = &pmic->reg_pdata[id];
int ret;
+ max77620_config_power_ok(pmic, id);
+
/* Update power mode */
ret = max77620_regulator_get_power_mode(pmic, id);
if (ret < 0)
@@ -595,6 +632,12 @@ static int max77620_of_parse_cb(struct device_node *np,
np, "maxim,suspend-fps-power-down-slot", &pval);
rpdata->suspend_fps_pd_slot = (!ret) ? pval : -1;
+ ret = of_property_read_u32(np, "maxim,power-ok-control", &pval);
+ if (!ret)
+ rpdata->power_ok = pval;
+ else
+ rpdata->power_ok = -1;
+
ret = of_property_read_u32(np, "maxim,ramp-rate-setting", &pval);
rpdata->ramp_rate_setting = (!ret) ? pval : 0;
@@ -807,6 +850,8 @@ static int max77620_regulator_resume(struct device *dev)
for (id = 0; id < MAX77620_NUM_REGS; id++) {
reg_pdata = &pmic->reg_pdata[id];
+ max77620_config_power_ok(pmic, id);
+
max77620_regulator_set_fps_slots(pmic, id, false);
if (reg_pdata->active_fps_src < 0)
continue;
diff --git a/drivers/regulator/tps6507x-regulator.c b/drivers/regulator/tps6507x-regulator.c
index dad0bac..c179a3a 100644
--- a/drivers/regulator/tps6507x-regulator.c
+++ b/drivers/regulator/tps6507x-regulator.c
@@ -375,7 +375,7 @@ static struct tps6507x_board *tps6507x_parse_dt_reg_data(
struct device_node *np = pdev->dev.parent->of_node;
struct device_node *regulators;
struct of_regulator_match *matches;
- static struct regulator_init_data *reg_data;
+ struct regulator_init_data *reg_data;
int idx = 0, count, ret;
tps_board = devm_kzalloc(&pdev->dev, sizeof(*tps_board),
diff --git a/include/linux/mfd/max77620.h b/include/linux/mfd/max77620.h
index 3ca0af07..ad2a9a8 100644
--- a/include/linux/mfd/max77620.h
+++ b/include/linux/mfd/max77620.h
@@ -180,6 +180,7 @@
#define MAX77620_SD_CFG1_FPWM_SD_MASK BIT(2)
#define MAX77620_SD_CFG1_FPWM_SD_SKIP 0
#define MAX77620_SD_CFG1_FPWM_SD_FPWM BIT(2)
+#define MAX20024_SD_CFG1_MPOK_MASK BIT(1)
#define MAX77620_SD_CFG1_FSRADE_SD_MASK BIT(0)
#define MAX77620_SD_CFG1_FSRADE_SD_DISABLE 0
#define MAX77620_SD_CFG1_FSRADE_SD_ENABLE BIT(0)
@@ -187,6 +188,7 @@
/* LDO_CNFG2 */
#define MAX77620_LDO_POWER_MODE_MASK 0xC0
#define MAX77620_LDO_POWER_MODE_SHIFT 6
+#define MAX20024_LDO_CFG2_MPOK_MASK BIT(2)
#define MAX77620_LDO_CFG2_ADE_MASK BIT(1)
#define MAX77620_LDO_CFG2_ADE_DISABLE 0
#define MAX77620_LDO_CFG2_ADE_ENABLE BIT(1)