[SCSI] lpfc 8.1.2: Add ERROR and WARM_START modes for diagnostic purposes.
Add ERROR and WARM_START modes for diagnostic purposes.
Signed-off-by: Jamie Wellnitz <Jamie.Wellnitz@emulex.com>
Signed-off-by: James Bottomley <James.Bottomley@SteelEye.com>
diff --git a/drivers/scsi/lpfc/lpfc_crtn.h b/drivers/scsi/lpfc/lpfc_crtn.h
index 0ae4981..cafddf2 100644
--- a/drivers/scsi/lpfc/lpfc_crtn.h
+++ b/drivers/scsi/lpfc/lpfc_crtn.h
@@ -1,7 +1,7 @@
/*******************************************************************
* This file is part of the Emulex Linux Device Driver for *
* Fibre Channel Host Bus Adapters. *
- * Copyright (C) 2004-2005 Emulex. All rights reserved. *
+ * Copyright (C) 2004-2006 Emulex. All rights reserved. *
* EMULEX and SLI are trademarks of Emulex. *
* www.emulex.com *
* *
@@ -107,6 +107,7 @@
int lpfc_config_port_prep(struct lpfc_hba *);
int lpfc_config_port_post(struct lpfc_hba *);
int lpfc_hba_down_prep(struct lpfc_hba *);
+int lpfc_hba_down_post(struct lpfc_hba *);
void lpfc_hba_init(struct lpfc_hba *, uint32_t *);
int lpfc_post_buffer(struct lpfc_hba *, struct lpfc_sli_ring *, int, int);
void lpfc_decode_firmware_rev(struct lpfc_hba *, char *, int);
@@ -123,6 +124,7 @@
void lpfc_read_rev(struct lpfc_hba *, LPFC_MBOXQ_t *);
void lpfc_config_ring(struct lpfc_hba *, int, LPFC_MBOXQ_t *);
void lpfc_config_port(struct lpfc_hba *, LPFC_MBOXQ_t *);
+void lpfc_kill_board(struct lpfc_hba *, LPFC_MBOXQ_t *);
void lpfc_mbox_put(struct lpfc_hba *, LPFC_MBOXQ_t *);
LPFC_MBOXQ_t *lpfc_mbox_get(struct lpfc_hba *);
@@ -135,6 +137,11 @@
struct lpfc_iocbq * lpfc_sli_get_iocbq(struct lpfc_hba *);
void lpfc_sli_release_iocbq(struct lpfc_hba * phba, struct lpfc_iocbq * iocb);
uint16_t lpfc_sli_next_iotag(struct lpfc_hba * phba, struct lpfc_iocbq * iocb);
+
+int lpfc_sli_brdready(struct lpfc_hba *, uint32_t);
+int lpfc_sli_brdkill(struct lpfc_hba *);
+int lpfc_sli_brdreset(struct lpfc_hba *);
+int lpfc_sli_brdrestart(struct lpfc_hba *);
int lpfc_sli_hba_setup(struct lpfc_hba *);
int lpfc_sli_hba_down(struct lpfc_hba *);
int lpfc_sli_issue_mbox(struct lpfc_hba *, LPFC_MBOXQ_t *, uint32_t);