input: TSC: ti_tscadc: set FIFO0 threshold Interrupt
Code currently uses FIFO1 threshold interrupt.
since this is a MFD, Dedicating FIFO0 to touchscreen
and making way for other devices to use FIFO1 as well.
The FIFO can be shared between 2 devices but since the
interrupt used is threshold interrupt on FIFO1, we would
end up having wrong interrupts. Hence changing the same.
Signed-off-by: Patil, Rachna <rachna@ti.com>
Signed-off-by: Samuel Ortiz <sameo@linux.intel.com>
diff --git a/drivers/input/touchscreen/ti_tscadc.c b/drivers/input/touchscreen/ti_tscadc.c
index c1bd8e5..2cc19b0 100644
--- a/drivers/input/touchscreen/ti_tscadc.c
+++ b/drivers/input/touchscreen/ti_tscadc.c
@@ -42,6 +42,7 @@
#define REG_STEPCONFIG(n) (0x64 + ((n - 1) * 8))
#define REG_STEPDELAY(n) (0x68 + ((n - 1) * 8))
#define REG_FIFO0CNT 0xE4
+#define REG_FIFO0THR 0xE8
#define REG_FIFO1THR 0xF4
#define REG_FIFO0 0x100
#define REG_FIFO1 0x200
@@ -55,6 +56,7 @@
#define STPENB_STEPENB STEPENB(0x7FFF)
/* IRQ enable */
+#define IRQENB_FIFO0THRES BIT(2)
#define IRQENB_FIFO1THRES BIT(5)
#define IRQENB_PENUP BIT(9)
@@ -277,7 +279,7 @@
unsigned int fsm;
status = tscadc_readl(ts_dev, REG_IRQSTATUS);
- if (status & IRQENB_FIFO1THRES) {
+ if (status & IRQENB_FIFO0THRES) {
tscadc_read_coordinates(ts_dev, &x, &y);
z1 = tscadc_readl(ts_dev, REG_FIFO0) & 0xfff;
@@ -303,7 +305,7 @@
input_sync(input_dev);
}
}
- irqclr |= IRQENB_FIFO1THRES;
+ irqclr |= IRQENB_FIFO0THRES;
}
/*
@@ -446,9 +448,9 @@
tscadc_writel(ts_dev, REG_CTRL, ctrl);
tscadc_idle_config(ts_dev);
- tscadc_writel(ts_dev, REG_IRQENABLE, IRQENB_FIFO1THRES);
+ tscadc_writel(ts_dev, REG_IRQENABLE, IRQENB_FIFO0THRES);
tscadc_step_config(ts_dev);
- tscadc_writel(ts_dev, REG_FIFO1THR, ts_dev->steps_to_configure);
+ tscadc_writel(ts_dev, REG_FIFO0THR, ts_dev->steps_to_configure);
ctrl |= CNTRLREG_TSCSSENB;
tscadc_writel(ts_dev, REG_CTRL, ctrl);