tree bfeea21d5b565a39ff32718327eb993d9b29c4aa
parent 28da28365da3f3bea1d4b7212a8a40e4b9ac3229
author Viresh Kumar <viresh.kumar@st.com> 1312538557 +0530
committer Vinod Koul <vinod.koul@intel.com> 1314281018 +0530

dmaengine/amba-pl08x: Get rid of pl08x_pre_boundary()

Pl080 Manual says: "Bursts do not cross the 1KB address boundary"

We can program the controller to cross 1 KB boundary on a burst and controller
can take care of this boundary condition by itself.

Following is the discussion with ARM Technical Support Guys (David):
[Viresh] Manual says: "Bursts do not cross the 1KB address boundary"

What does that actually mean? As, Maximum size transferable with a single LLI is
4095 * 4 =16380 ~ 16KB. So, if we don't have src/dest address aligned to burst
size, we can't use this big of an LLI.

[David] There is a difference between bursts describing the total data
transferred by the DMA controller and AHB bursts. Bursts described by the
programmable parameters in the PL080 have no direct connection with the bursts
that are seen on the AHB bus.

The statement that "Bursts do not cross the 1KB address boundary" in the TRM is
referring to AHB bursts, where this limitation is a requirement of the AHB spec.
You can still issue bursts within the PL080 that are in excess of 1KB. The
PL080 will make sure that its bursts are broken down into legal AHB bursts which
will be formatted to ensure that no AHB burst crosses a 1KB boundary.

Based on above discussion, this patch removes all code related to 1 KB boundary
as we are not required to handle this in driver.

Signed-off-by: Viresh Kumar <viresh.kumar@st.com>
Acked-by: Linus Walleij <linus.walleij@linaro.org>
Signed-off-by: Vinod Koul <vinod.koul@intel.com>